Recent content by chris2fer

Heat just speeds the process up, but in turn is more likely to allow more hormone into the solution then it can hold. Hence why it crashes when cooked. But only in high mg/ml concentrations.

I have filtered up to 100 ml, which is 10 vials, with one whatman .22. I buy sealed sterile vials. i put a 22 gauge pin on the male end of the whatman and screw the filled syringe on the other. Then filter. Also need pin in the sterile vial to vent the pressure.

Nvr said oral was more effective just curious as why u wanted then injectable. And ur right about the bb. All i was saying is that it isn't s easy to brew as u think. I'm speaking from experience. Its like putting Winstrol (winny) in oil. Just my opinion. I'm very interested in this brew. Keep...

Yeah i wasn't sure how I'd react too 100%.eo. But so far so good. I could have done 50\50 with gso, which is what I'll do next time.. I guess i should have mentioned that 100% oil or any combo with eo can be used.

What u keep is based on ur pct and diet.

What questions did you have. There are basic recipes that are tried and true.... I'm new to this board too.....

Test of coarse.first cycle was te 600mg a week. Gained 20 lbs and kept 15 of it. Lost 3% bf too. I taking adex too...

A little late posting on my part. Since that 150 was ur first pin i would start eod now. you'll be fine and it worked out good on ur part. I always pin more when i start...

Also found a recipe with no bb. So I'm not positive now. any other test brew is cake compared to tne. Imho try brewing any other test ester first so u get an idea of the process... Just my .02 cents

And why are brewing anadrol and halotestin?

This is 100mg/ml (50ml). 5 grams Test No Ester powder 2.5 ml BA 15 ml BB 5 ml Guaiacol 24 ml EO I think u need the bb. any reason its not being suspended in water?

Don't think tne goes in oil with ba and bb. Think it needs guical also. Should be in dtones sticky. And why are brewing orals? Cap em. Have you done any research?

Nvr crashed. There is no way it can as long as there are no crystals before u filter it means it's holding. Heating the oil or eo makes it expand. it's not a noticeable amount but enough to allow more hormone into it. Then it cools and crashes cause that particular solution is fully saturated.So...

After reading and researching i decided to make test prop 100mg/ml without heating. 30 ml total 3g prop 2.5% ba 15% bb EO Put powder in breaker added ba, bb and eo. Covered with Saran wrap and let it sit. Swirling it every few min. Took about 25 min for all the prop in dissolve. Was...