Recent content by Iliveforthis

  1. I

    test cyp crash

    I just heated it cleared rigt up do you think it's still ok ? Thanks....
  2. I

    test cyp crash

    Hey guys had some test cyp crash 250Mg/ml just curious if I can save it or if it's shot any help is great thanks....btw it was about 50°f
  3. I

    confused please help

    Hey JS11 I checked my mp again and it starts to melt at about 95c and is melted by 98c is that low enough to make a difference ?
  4. I

    confused please help

    Not sure I use a very accurate digital scale to weigh the powder . is there a better way?...btw thanks for all the help...
  5. I

    confused please help

    Not sure JS11 10g powder for a total of 40 cc finished product should be 250mg/ml. But do you think it could be my BA,BB, screwing something up just odered it off the net... is there a way to check it?
  6. I

    confused please help

    Thank JS11 I put the vial in the fridge over night all I see is a little separation but it did not crash. Good idea so just gotta figure where to go from here...Thanks again
  7. I

    confused please help

    so here is the deal i made my home brew test cyp 250 mg/ml. The melting point on the powder is good but not getting acne as i did with med grade stuff @ 500 mg wk. And I've went all the way to 1000 mg wk on the home brew and nothing don't even notice it...so the question I have is could it be...
  8. I

    Is my powder legit?

    Sounds like the same smell thats good to know. Kinda thought it could be in my head. Good to hear you had the same deal thanks for the info c4a...
  9. I

    Is my powder legit?

    Well c4a it is hard to tell kinda smells like hot plastic but I can't pin it ... What should it smell like?
  10. I

    Is my powder legit?

    Hey guys just wondering if there are any other ways besides MP test to find out if my powder is legit. I have some test cyp powder MP is 95C and it brews great just don't feel like it is working.This is my fourth cycle but my first with this gear. Any info would be great...:wallbash:
  11. I

    sterilizing after conversion

    Thaks for the info that is exactly what i needed ...
  12. I

    sterilizing after conversion

    Hi guys I was just wondering what your take is on heat sterilizing after conversion. I have done it on a couple of batches of test cyp and heard both ways I use BA & BB in the 2-20 method and was told I don't need to sterilize and it makes it less potent. I also run it through a 0.45 whitman...
See more
Back
Top