Recent content by SmilingBob

You want to immediately replace the filter unit with a silicone septa and screw cap. Med and lab supplies and Amazon has them. Then you can draw through the septa with your big ole 50ml syringe. The septa and cap need to be sterilized beforehand and you want to perform the swap out quickly -...

Amazon.com: Presto 01781 23-Quart Pressure Canner and Cooker: Kitchen & Dining This is what I have used for my mycology experiments for years. This sucker is big. Best $70 I ever spent. Over 100 cycles (my runs are usually 90 minutes long too) it is just now starting to leak a very small amount...

I have read that it is more difficult to verify the melt point of Sustanon (sust) because of the 4 different esters, but did you perform a melt test before your brew to verify the 37 degrees? What did your Sustanon (sust) look like in powder form and in the solution? You should have noticed...

I have never tried filtering that much in one session. I see your concern since the filters are not cheap. All I know personally is it can handle 500ml in a little over an hour and a half (I had problems getting the receiver bottle to seal tightly against the filter. In the future I will try a...

Yes that's correct. You need a sterile glass flask/bottle to hold your finished product and you need a device to create a small vacuum like either a hand pump or electric one.

There are some on amazon even. I have only used these filters with a glass media bottle, but I have had no issues. Filters fast enough for me. Look for something like this: Whatman ZapCap Chemically Resistant Disposable Bottle-Top Filters with Nylon Membrane, Whatman 10443421 They also have a...

You will burn about 1700-2200 calories just from resting all day, depending on your age and sex. This is called your Basal Metabolic Rate (BMR). Anything else you do on top of this burns more calories. So with a little weight lifting and cardio, you should be in a calorie deficit (which means...

Never made tren myself, but maybe more info will help a person answer. What happens when you reheat the enth? Will it go back into solution? And that ace description sounds scary. Possibly also tell what temp you brought it to and for how long and filtering temp into what filter. Good luck

First off, this is the chemical study section - the conversion of raw materials. Your topic would fall under the category of natural and steroid alternatives. You should post in that section to get the views you are looking for. Second, ostarine is not a steroid. It is a SARM. You do not need a...

If this is GH, then you would pin the entire contents of the bottle (= 10iu). Then have blood drawn 3.5 - 4 hours afterwards. No exercising that morning.

http://www.steroidology.com/forum/anabolic-steroid-forum/157651-injection-site-pain-read.html Maybe this will help

Are you positive you can perform a correct IM injection? Also 1.5" would be a better choice for quads if you have large legs. 1.5cc is not an extreme volume by any means so I don't think your problem is to much oil. Not sure about the general puffiness though.

I am interested in testing IGF also. I do know, however, that the protocol would be different for IGF than HGH. You would inject 100 mcg (or something similar) and not 10iu. IU = 1/100cc (this is volume) and mcg = 1/1000 mg (this is weight)

So PIP can be caused by different types of pain/aches/soreness all lumped together under the term PIP. Deep tissue soreness probably from a large volume-related injection and/or virgin muscle syndrome, redness and swelling from an infection, or an acute pain most likely caused by direct contact...

Why do the big name drug companies use up to 20% BB in their long ester injectables? Thousands of people on testosterone replacement therapy (TRT) could have well over 100ml BB injected into themselves by the time the die. Is there just a lack of long term studies that show detrimental effects...