Recent content by Topher82

I pinned the out side spot in the pic. It would be right on the border of the upper and lower quadrent. There iss plenty of muscle there so I'm not sure why shouldn't pin there. Does that make more sense chinaW

It was my right quad. I read up on where to pin in my quads and that was my understanding. Pinned a good ten times with this being my first issue. I'll try to find the link. howtodoinjections.com/IM/quads.html

Not to mention if you've ever used a ugl who knows how clean they are or where they are making it.

Been using my gear for 4 weeks. No issues. I'm up 15 lbs. Bf staying the same. Imo it's not the gear. I'm rotating between quads and glutes.if you research and ask questions about things you don't understand, making gear isn't hard.

I use 25g. I pinned in the lower right quadrent if that makes sense. Made the gear myself. Have had a little pip bit nothing other then that an't other time.its feels like fluid a little above my knee. About 6inches below my pin

I pinned 150 mg tren ace and 100 prop in my quad. everything went smooth. 1 day later I notice my knee swollen and really hurting, and got progressively worse through out the day. I've read that the gear can leak out of the muscle if not deep enough or if the shot was not in the right spot is...

k thanks.i did filter with whatman.22. the tp was dissolved before the oil went in. my main concern was that it affected the quality being so hot. But people bake their gear after so I'm sure I'm good.

I'm new to this forum. Don't get me wrong everything I've learned about brewing is from this site, it's that I just registered. I found my answer for the most part in someone elses thread.

When making test p I mixed the powder ba and bb together then put the hot gso in the mix. When I say hot is was prolly 160-200°f. Is that not ok? Should the oil cool more. I should say that I've read the oil should be heated to sterilize thats why it was hot. I'm worried that it being so hot...