How long should it take?

[hollywooddisco]

Hey guys, I just started my fourth cycle. I've been off for about five months. I choose to do another test/deca cycle. Here's my question, I've always shot my quads, I alternate sides and try to vary the location. Since I started again it seems like its taking longer to shoot. Seems like the oil is pushing xtremely slow, it takes about 10 mins to push 2cc's. I'm using a 23g 1 1/2 in. pin and i've tried heating the barrel in warm water. Is it possible that I've built up too much scar tissue in the quads? Or am I just impatient? My legs are pretty lean, is it possible that I'm going too deep and going through the muscle with an 1 1/2 in. pin? How long should 2cc's take to push.

Thanx for the help

 

[hollywooddisco]

Different manufact. but same source, I know the stuff is good... I just think it's pushing xtremly slow. Maybe I'll try bigger pins if you think it'll help....

 

[sean usmc]

i would use a 1 inch and 23 guage ..tip warm up the gear in a heating pad it will cause molicules to move and thin it out temperarely which will allow it to flow through the needle alot smoother..now dont over heat it bro..ok