TEST E is too thick? Boil vial in hot water for a minute?

[Riki246]

So I got some test E and Im using a 3mL 1.5inch 25g needle and its not coming out right. Ive used this size before. Do you think boiling or running hot water over it will make it less thick?

Not a noob at injecting but always could use advice. Thanks in advance guys!

 

[tury694]

That is weird. What is the concentration? If you want you can heat the oil, but don't "boil" it. Your other option is to cut it with EO or sterile oil.

 

[blackjack]

After I draw, I recap the draw pin and pull the plunger to the bottom. Hold it by the cap and run under hot tap water for a minute. Change the pin and good to go. Nice and thin. I too use 25g and have no problems.

 

[halfwit]

It's a good thing if it takes a solid minute or two to inject; it reduces the damage you cause by forcing a high pressure stream into your tissue. Unless of course it's just not coming out - then hot tap water should be sufficient.

 

[49ER]

Use a 21g

 

[blackjack]

Use a 21g

Damn. I wouldn't wish that on anyone.

 

[tury694]

21g is not that bad on your glutes, but I would not dare jab that anywhere else. I use 18g and 21g for drawing but one day I was curious to see how bad a 21g was and it hurt a bit, but I've had more pain from quad pip than the 21g glute shot. Niner, are you pinning your delts with a 21g?

 

[JimiThing]

You can either warm the whole vial in a hot water (hot-not boiling) water bath or run hot water over the barrel of the pin after drawing and after warmed switch to your injecting pin and inject. Dont be in too much of a rush though, as was said a slow inject is your best bet anyway.

 

[ADenver]

One of those plug in candle warmers is perfect for heating up vials!