Recent content by cause4alarm

  1. cause4alarm

    Have your Raws been cut?

    That is nearly impossible. The thing is, if you buy raws domestically, more than likely they came from china anyways. The difference between US and china is that US has policies set in place to where no raw material leaves any factory to be distributed on the streets, which china doesn't have...
  2. cause4alarm

    Issues with Tren Ace, need assistance.

    That was just a test run at the 200mg batch, so after the accident I had none left. Next batch I'll do at 100mg. Buttman, I know we've discussed BB and BA quiet extensively before and I know you don't (or at least don't like to) use either. But should I be good with 2%/10% with the next...
  3. cause4alarm

    Issues with Tren Ace, need assistance.

    Thanks progear and buttman, I'll reduce it down to 100mg with my next batch. I think adding everything in the beaker at once will probably help as well because it did harden to the beaker and the glass stirring rod until heat got up there, this should prevent that from happening.
  4. cause4alarm

    Issues with Tren Ace, need assistance.

    Well, a few months back I had some issues with this tren ace and I posted pictures of what the Millipore looked like after the filtering process (it looked like a bunch of junk in the filter). After going through 50g (did 2 different batches) and nothing changed. Both batches also did this...
  5. cause4alarm

    Issues with Tren Ace, need assistance.

    Well I have some shitty news, I dropped the damn thing on the ground! Before I dropped it, I did bake it and it did clear back up. Unfortunately I didn't have time to wait and see if it clouded up again. It sucks because that was the last bit of ace that I had :( I was also thinking...
  6. cause4alarm

    Issues with Tren Ace, need assistance.

    After I posted that I thought about moisture, but there was no moisture present during the process. I use a hot plate, not the water in a pot method. I'm going to throw it in the oven and see if that clears it up any. I'll post with the conclusion.
  7. cause4alarm

    Issues with Tren Ace, need assistance.

    Hey guys, been having some problems with this tren ace and I can't seem to figure it out. Been brewing shit for years and this has been the only thing that's stumped me. 2% BA 10% BB Rest oil It looks perfect after the brew and then about 5 hours later it clouds up. I used to do the...
  8. cause4alarm

    Miglyol a superior carrier

    There's a site that sells it. Min purchase is 25k drum.
  9. cause4alarm

    Solid Test C?

    At least you know that lab is putting actual test cyp in their gear! This is extremely common with cyp, especially in the winter months. To allow the crystals to dissolve back into the oil, put a needle through the rubber stopper but not too deep where it's close to the oil (the oil will...
  10. cause4alarm

    Hormone Blend Calculator

    Could have used this shit last month! Thanks man, great work!
  11. cause4alarm

    Even when I'm not at work, I'm at work!

    Not the brightest idea to post pics of your labels. Check out this video and tell me what website you see about half way through, around the 1:20 mark ;) Investigators: "Key Player" in Illegal Steriod Ring Off Streets - www.kmtv.com
  12. cause4alarm

    pinn still good to go?

    I thought they would be a reliable source and I trusted the guys in charge but I had a buddy of mine tell me to research them a little more so I did, you might be surprised if you read other forums. I was also told ology deletes members posts if they say anything negative about pinn. Not...
  13. cause4alarm

    Test E and PIP (Post Injection Pain) Possible solution......

    Damn that was quite a process you did with trying to dry it! I'm sorry to hear that it didn't turn out the way you would have liked for it to but at least you did conclude there was phenol in the powder. The test e powder that I just bought I have no pip issues from so who knows, I don't...
  14. cause4alarm

    halotestin solubility?

    Damn right it is!! I've been wanting to get some but, fuck, that shit is crazy expensive!
  15. cause4alarm

    Tren Acetate powder...issue?

    Yes I did a melting point test and it melted right at 95C. It seemed like everything was good until I added oil and then it wouldn't combine? In a way, I thought the supplier could have possibly ground up finaplix pellets into a fine powder and sold it as tren ace. I bought 50g and it all...
Back
Top