Recent content by hardbody04

Like you said hard to crash but at 400mg it made it easy to split it for 2x week shots when running 400mg per week...shoots smooth very low BA for EQ. Thanks for the reassurance!

The converted is still in a good stat...it couldn't loose that much affect could it? EQ 400mg, test E 250mg, prop at 100mg/ml

OK hypothetical question....if powders were stored in freezer Tren A, EQ, Test E and Stan vacum sealed for about 3 years think its would lose any potenticy? what if you had some already converted that was going on 4 years or so has been kept dark and cool and never cyrstalized....With things as...

yep doesn't take long....i can see someone nukeing it for 2 minutes...

yeah i would be weary of the microwave too... take a small pan with water and heat it up place the vial with a pin in it to vent once the crystals melt let it go for a min or two then take it off and watch it for few days...

vent it with a pin and reheat it and see if it holds....if it doesn't you could add a some bb/oil it will just change the concentration a little bit...as said though im weary of someones test cyp that crystallizes grapeseed oil is what i like best

home brew? test cyp is a very easy solution to hold esp at that concentration it really shouldn't be crystallizing

good stuff thanks

Peg 300 should hold it...i think the glycerol and 151 is what a lot of folks are doing now

should be right at 1000ml 100,000mg/1000ml = 100mg/ml 75ml of test then your ba/bb/oil boom its done.

still in powder form i have not converted it...i figured it would either work or not my cycle doesn't really need it but it is nice to have to keep everything going well....Just didn't know if anyone had used any past the date and had results to post

melt test is about all you can do now....if your just an average joe or if its already converted no much you can do.

Well i have some left that i didn't get to use just says it expires in '08 well were getting close to rounding this year off will be December before i cycle again...does it hold any life or would you just chunk it?

Hey guys im not a big poster on this forum but i do visit and i know there are some top notch guys on here...(also i see the chem section is gone wanted to put this here)....? Can a mod PM me or let me know who i can PM about good reputable UGL going down...it has been very hush hush and i was...

I have some brew from 05 that was last used then...i have been off for while and will be starting back next month....i have a few vials that were 50mls that are half empty. with the air in the vials would you use the gear? add a little ba or what. i was just going to refilter to new vials but...