HCG Detailed Instructions

comeback kid

New member
Found this article on the George Washington University Medical Faculty Associates Journal. Some of the amounts are different, but same concept.Thought I'd share it:

Medication administration: hCG (Profasi, Pregnyl, Novarel, Ovidrel)

The hCG comes packaged as a powder containing 10,000 units of hCG. A diluent (liquid vial) is supplied to make a solution for injection. Wash your hands well with soap and water prior to administering the injection. In order to prepare your injection:

Using the 3 cc syringe, draw up only 1 cc (1.0 cc = 1.0 ml) of liquid (diluent). Slowly inject this liquid into the powder vial down the side of the vial to avoid foam. Remove the syringe (and recap it) to make mixing easier. This bottle will need to be gently rotated to get all of the powder into solution. Do not shake the bottle is this adds bubbles to the solution. After mixing, this solution may be clear or milky white in color. You will not need any extra liquid left over in the original diluent vial.
Once the powder is completely dissolved, invert the bottle in order to draw up the entire contents back into the syringe. (Always make sure that the tip of the needle is below the liquid level in the bottle to recover as much of the solution into the syringe as possible. It will be necessary to slowly back the tip of the needle out of the vial as you withdraw the fluid.) Make certain that the powder has completely gone into suspension, that there are no clumps of undissolved powder on the sides of the bottle.)
Continue to pull back on the plunger of the syringe so that there is an air space of about 1 cc near the needle end of the syringe. You will be removing the long needle from this syringe and replacing it with a small needle for your injection. Pulling back on the plunger of the syringe insures that you will not leave any medication in the needle which is to be removed.
Remove the long needle from the syringe after CAREFULLY capping it by untwisting it from the syringe. Dispose of the needle in a safe, puncture proof container. BE CAREFUL WHEN YOU REMOVE THIS NEEDLE SO THAT YOU DO NOT STICK YOURSELF.
Replace this needle with the 27 or 30 gauge needle by screwing the smaller needle onto the syringe.
Keeping the syringe in a upright (vertical) position so that the needle is at the top, slowly push up on the plunger of the needle to remove any air from the syringe. Keep pushing until all visible signs of air are removed from the syringe and you see a tiny droplet of liquid being expressed from the point of the needle.
Choose the location where you plan to administer the subcutaneous injection. Most patients give the injection in the lower portion of the abdominal wall between the pubic hair line and the belly button. For the hCG injection, this area seems to be less sensitive. However, the medication can also be administered in the upper outer arm, buttocks, or thigh. Wipe the area in circles going outward with an alcohol wipe. The rationale for this is to drag any bacteria away from the site of the injection. Let the alcohol air dry (do not blow on it) prior to injecting to minimize any stinging. Please see the sheet at the end of this section for pictures of the possible sites.
Pinch the skin between your thumb and forefinger at the injection site. Holding the needle like a dart in your other hand, insert the needle into the area of pinched skin, the entire length of the needle. Let go of the pinched skin.
Completely depress the plunger to deposit the medication into the tissue. There is no need to draw back on the plunger prior to injecting this medication.
Remove needle from skin. Cover with Band-Aid if necessary.
Your egg retrieval will be scheduled to take place approximately 36 hours after your hCG injection, so it is important to take the hCG as close to the exact time specified by the physician as possible.
Helpful Hints

If you contaminate the needle in the process of making the solutions, recap the needle, twist it off, and take a fresh needle from another syringe.
Syringes should be discarded appropriately after a single use. They may be deposited in the syringe disposal container that you may have been given. Alternatives include any hard container such as a empty peanut butter jar, an old coffee can, or an empty 2-liter plastic soda bottle. When your container is filled, you can seal it with heavy tape, label it "Do Not Recycle" and dispose of it with your regular household trash. If you are getting your medications and syringe disposal container through a mail order service, you can contact them about disposal.
After mixing the diluent and powder it may be easier to withdraw the mixed solution by placing the needle just through the rubber seal and turning the vial over to withdraw the solution. This is because the needle may not reach the bottom of the vial and this will bring the solution to the needle.
Try to administer the medication immediately after mixing it, but certainly within 30 minutes, since it may not be as effective after that time.
Consider making yourself comfortable when giving the injection by lying down or sitting. As noted earlier, consider administering the hCG shot into the lower part of your abdomen (between your belly button and your pubic hairline) as this area is less sensitive.
Side effects of hCG (Profasi, Pregnyl, Novarel, Ovidrel)

It is important to know that while hCG can cause ovarian hyperstimulation, there are usually no side effects associated with the hCG injection and most women tolerate this medication quite well. Do not be alarmed if there is some reddening or a small red raised area at the injection site or if you feel some itching or stinging. If you develop a blister or swelling greater than the size of a half dollar, please call the office.


SOURCE: hCG (Profasi, Pregnyl, Novarel, Ovidrel, hCG)

George Washington University. Medical Faculty Associates
 
Great read but one thing still confuses me. I have one amp 5000iu powder 1 ampof solvent. O.k. I understandhow to mix them. I dont have a sterile 10ml vial so I was gonna load up my slin pins with 250iu each. How im going to measure that im clueless since the slin pins are in units. Also i was reading i need to refegirate them after putting in the mix, but they only stay good for 10 days that sucks cause I was gonna take 250 2x week for my 8 week cycle. So it expires in 10 days? How many units=250iu with one bottle of solvent? Help on this would be greatly appreciated.
 
Great read but one thing still confuses me. I have one amp 5000iu powder 1 ampof solvent. O.k. I understandhow to mix them. I dont have a sterile 10ml vial so I was gonna load up my slin pins with 250iu each. How im going to measure that im clueless since the slin pins are in units. Also i was reading i need to refegirate them after putting in the mix, but they only stay good for 10 days that sucks cause I was gonna take 250 2x week for my 8 week cycle. So it expires in 10 days? How many units=250iu with one bottle of solvent? Help on this would be greatly appreciated.

If you can get some BAC water it will stay good for 60 days. Did you already mix the 2? If not, ditch the water that comes with it and get some BAC water (bacteriostatic water). Then mix it like this into a 10Ml empty STERILE vial:
5000 iu HCG + 10 Ml BAC water
Then you have 500iu/Ml

The way you mix is to draw 1 Ml of BAC water and slowly mix it into the HCG ampule. That gives you 5000iu/Ml so you need to dilute it. Mix it good and draw it back into your syringe. Put it into the empty STERILE vial. Now add another 9 Ml of BAC water and Voila you now have a concentration of 500iu/Ml of HCG that stays good when refridgerated for 60 days.
 
Is Power4Home a Real solution to our energy crisis?

Hello everyone,

My name is Jay Tomlinand I am new to this forum. I am not sure if this is the right category that I should be posting this topic but forgive me if not. Recently I purchased this Power4Home program I am sure most of you heard of it already, but anyway I have been working on building the system with no past experience of electrical knowledge what so ever but I was finally able to finish building all the system after 3 days of work.

I must say it is an energy miracle that could end our global worming. I am no body really just trying to spread this information since our governments don't give a damm about this matter as long as they make their cut.

Please visit this website for more information: Power4Home Review - Does it actually work?
To those of you that think I make a dime in anyway the answer is NO I love earth more than any trash paper.

I don't know how many of you know about the seriousness of this situation but I think everyone should act NOW.

Thank you for reading this,
All the best
 
Back
Top