Liquid oral recipes!!

[cbman2184]

I have seen quite a few posts on asking how to make liquid orals so I thought i would share these recipes.



ANADROL
Powder: per 1 gram of Oxymetholone
Produces: Highest concentration made ***8211; 50mg/ml

Requirements:
1 gram of Oxymetholone powder
1 Beaker suitable for holding the volume of liquids
8.4ml of PEG 300
10.5ml 190 Proof Grain Alcohol

ANAVAR
Powder: per 1 gram of Oxandrolone
Produces: Highest concentration made ***8211; 20mg/ml

Requirements:
1 gram of Oxandrolone powder
1 beaker suitable for holding the volume of liquids
9.8ml of PEG 300
39.2ml of 190 Proof Grain Alcohol

ARIMIDEX
Powder: per 1 gram of Anastrozole
Produces: Highest concentration made ***8211; 5mg/ml

Requirements
1 gram of Anastrozole powder
1 beaker suitable for holding the volume of liquids
19.9ml of PEG 300
179.1ml of 190 Proof Grain Alcohol

CLOMID (Version I)
Powder: per 1 gram of Clomiphene Citrate
Produces: Highest concentration made ***8211; 50mg/ml

Requirements:
1 gram of Clomiphene Citrate
1 beaker suitable for holding the volume of liquids
7.6ml of Glycerol
11.3ml of 190 Proof Grain Alcohol

CLOMID (Version II)
Powder: per 1 gram of Clomiphene Citrate
Produces: Highest concentration made ***8211; 50mg/ml

Requirements:

1 gram of Clomiphene Citrate
1 beaker suitable for holding the volume of liquids
8.4ml of PEG 600
10.5ml of 190 Proof Grain Alcohol

DIANABOL
Powder: per 1 gram Methandrostenolone
Produces: Highest concentration made ***8211; 50mg/ml

Requirements:

1 gram of Methandrostenolone powder
1 beaker suitable for holding he volume of liquids
19ml of 190 Proof Grain Alcohol

FEMARA
Powder: per 1 gram of Letrozole
Produces: Highest concentration made ***8211; 5mg/ml

Requirements:

1 gram of Letrozole powder
1 beaker suitable for holding the volume of liquids
19.9ml of PEG 300
179.1ml of 190 Grain Proof Alcohol

NOLVADEX (Version I)
Powder: per 1 gram of Tamoxifen Citrate
Produces: Highest concentration made ***8211; 20mg/ml

Requirements:

1 gram of Tamoxifen Citrate
1 beaker suitable for holding the volume of liquids
19.6ml of Glycerol
29.4ml of 190 Proof Grain Alochol

NOLVADEX (Version II)
Powder: per 1 gram of Tamoxifen Citrate
Produces: Highest concentration made ***8211; 20mg/ml

Requirements:

1 gram of Tamoxifen Citrate
1 beaker suitable for holding the volume of liquids
9.8ml of PEG 600
39.2ml of 190 Proof Grain Alcohol

PROVIRON
Powder: per 1 gram of Mesterolone
Produces: Highest concentration made ***8211; 50mg/ml

Requirements

1 gram of Mesterolone
1 beaker suitable for holding the volume of liquids
8.4ml of PEG 300
10.5ml of 190 Proof Grain Alcohol

WINSTROL
Powder: per 1 gram of Stanozlol
Produces: Highest concentration made ***8211; 25mg/ml

Requirements:

1 gram of Stanozlol
1 beaker for holding the volume of liquids
7.8ml of PEG 300
31.2ml of 190 Proof Grain Alochol

For all of the above conversions requiring PEG and 190 Proof Alcohol, use the following procedure;
Place a sufficient amount of water in a pan and place on the stove
Remove from heat when the water reaches boiling temperature
Place the powder and the PEG in the beaker
Immerse the beaker in the pan of water so that the water is level with the top of the contents of the beaker
Gently swirl or stir the contents of the beaker until the solution is clear (reheat the water if necessary)
Remove the beaker from the water
Allow the PEG to cool down
Slowly add the 190 Proof Alcohol to the mixture
Gently stir until fully mixed.

For all of the above conversions where PEG is not required, use the following procedure;
Mix powder and 190 Proof Alcohol in the beaker
Gently swirl or stir the contents of the beaker until the solution is clear
The majority of powders which do not require PEG will dissolve rea dily but those that are troublesome, refer to the heating procedure as outlined above.
In the event that 190 Grain Alcohol (EverClear) is unavailable, you could substitute Bacardi 151.
List of Materials:
190 Proof Grain Alcohol or Bacardi 151, PEG 300, PEG 600. Powder, beaker, stir rod, suitable container for holding finished preparation. Weighing scales accurate to 0.001g (if preparing yourself)

You never want to be in a situation where you have to shake it up to use it. While it***8217;s good to shake a solution to ensure even distribution throughout the liquid, you should always prefer to have all of your powder dissolved and not to be able to see any crystals floating around in the liquid
Ideally you want a solution, not a suspension. If you have a preparation which is little more than powder sitting in liquid, or where after swirling it visibly falls down to the bottom of the vial, it is utterly useless for getting any kind of consistency of dosing. Anything worthy of being called a suspension should be fairly stable after shaking such that you can take your time to draw it.

 

[PerfectAnimal]

I'm looking for Aromasin -Exemestane recipe. 25mg/ml would be great.
Anyone has a checked recipe ?

 

[J-Radical]

Anyone have one for Cialis with peg 300 and everclear??

 

[traps09]

Nice post.

 

[DrHouse]

Edited my post because the instructions for anavar doesn't really work as expected. My tip:

Add the PEG 300 to powder. Heat for a while until the crystal sizes get smaller, then add the alcohol and heat again until the crystals are fully dissolved. It has taken me a while to get to this point but it has worked.

Goodluck with the rest of these. I will be trying Clomid, Nolva and Arimidex eventually.

 

[J-Radical]

Just ran into the exact same problem.

Anavar recipe was a failure. Just information to prevent the next person from messing up.

I don't have any tips at this point but I will continue to play around with mine.

 

[DrHouse]

Just ran into the exact same problem.

Edited my post. Hope this helps buddy.

 

[J-Radical]

Did it stay suspended. I did the same thing and the next day it was crashed...

 

[DrHouse]

Did it stay suspended. I did the same thing and the next day it was crashed...

Just made it today. I guess I will have to wait to find out.

I think the best case scenario with this recipe is a suspension that will last long enough to dose after shaking.

 

[J-Radical]

I reheated it and it went clear again. It stayed like that all day. I will report back what happens. Hopefully it stay suspended.

 

[DrHouse]

Same here. Reheated and allowed to cool slowly and so far so good.

Clomid, and nolva recipes are working good too.

 

[J-Radical]

Just checked my var again. Yup it crashed again. The crystals stick to the side of the bottle so even when I shake it they all do not come off. Interested to see how you make out.

 

[smadizm1]

Just cap them haha

 

[DrHouse]

Mine is still in solution. The only thing I did differently was allow it to cool slowly.

 

[SamSport]

I'm looking for Aromasin -Exemestane recipe. 25mg/ml would be great.
Anyone has a checked recipe ?

I'm gonna attempt 20mg/ml in a week.. I use Bacardi 151 + aromasin.. Right now I did it at 12.5 mg/ml with only bacardi and no problem at all (stay in solution). I'll update when I'm done

 

[J-Radical]

Just cap them haha

haha That's what I usually do. I just wanted to experiment and see what would happen.

 

[J-Radical]

Mine is still in solution. The only thing I did differently was allow it to cool slowly.

I tried that as well. I cant get it to stay for more than a few hours. SO frustrating.

I think Im going to give Cialis at 20mg per ml a try a little later. Im going to use the same recipe as the anavar and maybe throw in some peppermint extract and see how that goes.

 

[DrHouse]

Are you dissolving in alcohol and peg? I noticed when I corrected the volume the first time with alcohol, it cooled it too quickly so I heated the alcohol I added to the final product beforehand as well.

 

[J-Radical]

Ive tried to dissolve the var in peg only (didn't work) then I added the everclear (didn't work) then I tried them both together and different methods and I just cant get it to hold.

 

[DrHouse]

Ive tried to dissolve the var in peg only (didn't work) then I added the everclear (didn't work) then I tried them both together and different methods and I just cant get it to hold.

Add peg, var, and some amount of ever clear. No more than required though. I used an electric griddle on approximately 225-230 degrees F and stirred occasionally until it was dissolved. Gradually turn down the heat until it has cooled on its own. Should hold. I have a few that rather large crystals form but only one out of 16 has done it lately. Hope this helps. Feel free to pm me