new gear...f ake?

[aladin12]

i tried a new brand (nupharm)

and first of all, my first cycle i ran something different, it took forever to pull out of the vial with a 25g 1 inch (i pulled and injected with the same size needles)

and it took forever to inject, like 40 seconds a cc

i'm about to start my new cycle with this gear, and it took no time to get into the syringe, (a lot faster then the previous) and i haven't injected, but my first brand i had to pull down on the plunger as hard as possible and it took 30-35 seconds still for a cc,
basically i think this is going to inject really fast, and i'm thinking it's fake, any input?

 

[aladin12]

sorry for dpouble but i just watched some injection vids
youtube.com/watch?v=azF1FoepHuo
that guy at the end injects 1cc in like 5 seconds, so maybe it's not fake afterall.

 

[3dbowmaster]

Dont think i would judge it because of consistency. Y the heck u pulling with a 25 for anyways? Its bad enough with 22

 

[hijacked]

You cant judge the quality this way. If it was made with 100% ethyl oleate as a carrier its going to pull with ease, even with a 25 g pin. Some labs list the ingredients including the carrier. Does it say on your vial?

 

[aladin12]

it doesn't say, and when i injected it it took almost just as long, (just did first shot) i guess the only way to tell is time.

 

[H 3 L L S M A N]

MAKE SURE you warm your gear up properly, this can be done alot of ways but I am now a fan of running hot water over the syringe barrel before injection. I leave the draw tip on and then switch to the pinning tip after heating under the water. Just be sure to only get the water on the barrel and not near the tip because the water is not sterile.