My first experience with test was prop and it was so painful I had to quit after two weeks. I got some test e and still have the prop so I was just wondering if I could cut the test prop buy using it with my test e.. In the same syringe any one ever tried this? I still want to inject e3d I just don't want this prop to go to waste. Would it fuck with my levels too bad or would it be kinda like sust
test e + prop
- Thread starter baaa
- Start date
snobE1226
New member
Imo save the prop, run the test e until 2 weeks from the end of your cycle and start pinning the p eod until the end of that 2nd week. There are things you can cut the p with, but I'm thinking it would be too hard to keep steady levels if you use both up front, someone else might say different though as I've seen some people doing this on the boards.
Last edited:
Jack Tors
New member
not necessarily depends on the test
Jack Tors
New member
its fine
the reason it hurts really bad is most likely due to your BA's are to high in your prop. This is a common problem with UG prop and other types... you can do the bake method to bring this down some. This is done by maxxing your surface area for oil such as taking stopper out and putting in oven at 200 degrees for 30 mins then let cool and repeat for several hours total bake time. This keeps powder from being damaged and also usally takes BA's down .02 per. 2 hours. Now this is what I've been told by a home brewer and just passing along the information. But mixing with clean oil such as 1ml of oil per 1ml of prop. would help a great deal also.
i just meant that's what *I* i was doing.. sorry for the confusion
godbullsteroid
New member
maybe you should got some high quality test porp powder
1.5 cc of your test equals 750mg? Damn man, that home brew? That's ALOT!
Similar threads
