Recent content by FabianElColombiano

so I heated up boiling water and placed this glass inside boiling water so as to heat up chemicals and finish conversion. One pic is what it looks like hot. Other one when it cools off. Neither one looks right. I did not have a problem at all suspending the synovex. Can you please help me by...

/So then heat up in boiled water? Stick chemical in container and place in heated water to melt?

So I did everything correctly with HEET, LYE, and water filtering. Let it dry into powder. I did this with two carts of REVALOR. So this is what I added on solvents and oil. BA 1ml BB 7.4 and grape seed oil 32ml. I then stuck in microwave a bit like I did my synovex to heat it up and melt. The...

Can leaving Syno in heet to long without lye actually strip prop as well? Or is that only with lye?

So once the prop is gone it will not last for a day and a half ? Just right after wards. hmmm. Not as effective then right?

I have been reading on this conversion and have only found one thread that describes the difference between synovex with prop removed and left as pure test and how it is supposed to be if converted right with prop. Here are my questions. Is pure test still good for use? Will it still give...

So the test with no ester in it is still ok to use? Inject EOD? This is the only thread I have found that sort of explains the difference with converting synovex. If done right it keeps prop if not then its just pure test right? My question, is it ok to still use if PROP is striped from it?

Ok so for 5 carts of syno. Since this is already filtered and in powder form how much HEET and lye do you recommend I use to remove estro? I am guessing 1 hour again in Heet and do water once again to crystallize it? Please advise on these few questions I have. Also thank you very much for...

I was thinking this might be a method or correcting my error? placing already filtered synovex with Estro still in it into new solution of heet with LYE in it to remove estrogen and filter again? Would this solve my problem?

So I really need some advice on a conversion mistake I made on some syno. I did the complete conversion with heet, filtering,water etc. It is now in dry powder form. The thing is while I was converting I did not read ahead on the basskiller tutorial and read that I needed some LYE in order to...