22g 1.5'' for quad injection?????

[knuckles101]

is a 22g 1.5" for a quad injection to big??? running test and eq through it

 

[estray]

The guage is unnecessarily big. A 25g works fine for injecting, goes a little slow but a hell of a lot less painless. Draw with a 22g from the vial.

 

[g1234]

I use 23g 1" for everywhere. But yes estray is right smaller is better, I would use 25g 1" if these were available in pharmacy here.

 

[Die$eL~Man]

i would go with 1" for quaDS

 

[Biggin]

23g 1in everywhere for me.

 

[bigospreys7]

25g, 1" everwhere for me, but everyones different, but would defo use 1".

 

[knuckles101]

ok thanks guys

 

[auga]

i use 21 22 23 1.5 everywere and i pretty much burry it. i leave about an eighth inch just incase it ever broke i would b able to pull it out. use 18g to draw the shot it works great. i have actually used an 18g to shoot before. the Sustanon (sust) redijects came with 18g needles. it looks like you gave yourself an extra asshole after you shoot it LOL

 

[jackt]

it's unnecessary to use anything but 25g 1" IMO. some might need 1.5 in the glute if there's alot of fat, but you certainly dont need it in the quad.
and i feel your pain with the 22g, thats what I started out with several years ago. you'll realize the unnecessary pain youve been putting yourself through once you start using 25g (run it under hot water before you inject)

 

[fistfullofsteel]

yikes, 22 gauge. those are going to leave some nice tissue scars.

 

[Ythrashin]

To damn long for your quad... go with a 23g or 25g 1inch pin.

 

[Jack Mehoff]

i use 21 22 23 1.5 everywere and i pretty much burry it. i leave about an eighth inch just incase it ever broke i would b able to pull it out. use 18g to draw the shot it works great. i have actually used an 18g to shoot before. the Sustanon (sust) redijects came with 18g needles. it looks like you gave yourself an extra asshole after you shoot it LOL

18g will punch holes in your stopper and leave little rubber pieces floatin around in your Sauce*** a 22g or 23g to draw is plenty big.

***(Copyright BIGGIN)
^^didnt feel right stealin your word without giving yah credit

 

[Ythrashin]

I agree...hell I even had probs with 19g taking chunks outa my stopper.

 

[jackt]

you lose the gear left in the pin when you switch drawing and injecting pins. drawing with an 18/19g pin will end up wasting way to much juice imo, unless you're having problems with your stuff not flowing through easily, you don't ever need to draw it up with anything bigger than 22g

 

[THE-DET-OAK]

well i flip the syringe upside down and draw back a lil-this will save from wasting during the switch

 

[THE-DET-OAK]

either way-i can draw with a 25-so 19 is too big

 

[Ythrashin]

you lose the gear left in the pin when you switch drawing and injecting pins. drawing with an 18/19g pin will end up wasting way to much juice imo, unless you're having problems with your stuff not flowing through easily, you don't ever need to draw it up with anything bigger than 22g

Thats why you draw in some air clearing the needle before switching.

I even leave a little air bubble in the top of the syringe to clear the needle when injecting.

 

[jackt]

either way-i can draw with a 25-so 19 is too big

agreed, if it flows through the 25g then thats what i draw with as well

 

[GymLift]

I've used 1.5" 22G for my vastus lateralis (quads). Saves me some time. 1" is sufficient but I've used 1.5" by mistake a few times no issues.

 

[scouser5]

23g 1.5" in glutes
25g 1" everywhere else.
Did go 22g 1.5in in quads on first cycle and it felt like it took 10minutes for the entire needle to go in.