Conversion Kit Filters

[WannaBe]

Do yourself a favor and order two whatmans when you get your kits. The first 10ml flow nice, then it is a drop a second for the next 20. Sometimes slower. Just flush both if you are concerned about losing any in the filters.

 

[Exkon]

I have converted Fina twice and never had any problems. Check to make sure the filter isnt to tight on the syringe. I noticed when I did that the flow was really slow, but also make sure its not too loose otherwise you will lose some tren.

Then again, better safe then sorry so why not spend the extra $8

 

[iced]

yeah, make sure it is tight definitley. Also, use a 3ml, i know more loading the syringe etc, but you can put much more pressure on the oil, and it squirts out faster. I could barely get my oil to move in a 20ml syringe, let alone a 10 ml. But, again it must be tight. I learned my lesson after i accidently had 10mls all over me.

 

[BiggieSwolls]

This is a good thread. I personally always buy extra filters. Not only can it be a bit of a bitch to get through the filter after you have already filtered 10-20 ml's but sterility then comes into question when you see how dirty that filter gets.

My thinking on that is you mine as well spring the extra couple bucks so that you can ease your mind about the sterility of your end-product.

I am going to make a copy of this thread available to the "Chemical" forum as well.

 

[DangerousGrounds]

I did all mine at one time and flushed out with Ever-Clear. Should have seen all the shit come out. I did it a few times than hot water. Its made of fiberglass so won't harm filter good to keep a backup or 2 on hand,

 

[superman1975]

I did all mine at one time and flushed out with Ever-Clear. Should have seen all the shit come out. I did it a few times than hot water. Its made of fiberglass so won't harm filter good to keep a backup or 2 on hand,

DG is right---you can clean and reuse your filters

 

[DangerousGrounds]

do so immediately and almost good as new. If dries I think it may not clean as well but mine is like brand new

 

[Billy_Bathgate]

Microwabe it or something though, soak it in alcohol etc..., the sterile side inside the tube is now contaminated if youve been playing around with everclear and water lol.

You can reuse them though. They can be found for about a buck each though anyways, id just get a new one.

 

[clee]

Billy_Bathgate
where can they be found for a buck??

 

[superman1975]

yeah no shit billy where?

 

[Billy_Bathgate]

BB4L will have em for cheap soon. Other than that, straight from the chemical companies if you have a business id or whatever.

 

[clee]

oh i have no ID thanks.

 

[Billy_Bathgate]

oh i have no ID thanks.

ya, thats why they usually are 5 bux or so. bought in bulk, they are under a dollar though if bought direct...its hard to unless your in that bus.