homebrew question

[tonespinnin]

So I decided to homebrew I got everything I need just waiting on the raw. Im just planning on runnig test .So after going back and forth between E and C I decided to go with the c. But now im getting a little paranoid about the holding thing . I dont plan on going crazy with the mg probably just 200 . just wanted to know if i follow the recipes correctly If im going to have a problem with it holding . any critisim or reasurrance would be appreciated.

 

[Machine5150]

you shouldn't have any issues.. i brewed cyp before, and was no harder than when i brewed test e.. just make sure not to let it get to hot.. nothing over 80 degrees Celsius.. it has a low melting point, remember that.

 

[UserAt204]

I had the same concern the first time but not to worry. Keep it at 200mg and 2/20 and you will have no problem.

 

[tonespinnin]

so i dont go to hot what do u guys recomend heating wise

 

[tonespinnin]

I read so much different ways . would u recomend mixing a together including oil then heat or mixing all but the oil melt then add oil , damn it gets confusing , just dont wanna waste my raw

 

[tonespinnin]

Sorry for all the questions what do u guys think about apanof water on a electric fry pan with the temp turned a couple degrees just above melting

 

[UserAt204]

This should be in chem forum. A mod will probably move it.

put a frying pan on the stove top at heat level 3 or so, I like to put some water in the pan also. Next set the beaker with ba/bb/powder in the pan and let the water/pan heat up the beaker. You will see the powder start to ***8220;melt***8221; or dissolve and it will make a mostly clear solution. You can use a glass rod to stir and speed up this process

After the ba/bb has dissolved the powder, Now pour in the 61.25ml of sterile oil and leave the heat on and stir with the glass rod for a few minutes, you will have a nice clear mixture.

I took this from the chem forum. Very easy to follow.

 

[Machine5150]

^^This is fine.. i like to add the powder last personally.. but to each their own.. it is like asking what to add first when baking a cake eggs flour or sugar?? it really doesn't fvcking matter what order you do it in as you will get the same result no matter what.. i just like being able to dissolve the powder into the oil rather than melt the powder then add oil

 

[tonespinnin]

thanks bro appreciate it greatly does it matter if itd sterile oil or not i got some grape seed not sterole though

 

[UserAt204]

Great advice machine. I was going to post both ways but I'm lazy. No you don't need sterile oil. Just buy it from the grocery store. You filter it to make it sterile.

 

[Machine5150]

^^^^Yup.. User is right

 

[glubgawd]

Great advice machine. I was going to post both ways but I'm lazy. No you don't need sterile oil. Just buy it from the grocery store. You filter it to make it sterile.

^ this. the pre-filtered stuff is outrageously expensive considering all they do is run it through a filter (which you need to do anyways).