New here and ID peptide question

prefontaine1973

New member
Hello all, I am a regular on another board but decided to stop in here because they never talk about peptides where I usually roam.

Anyway I have been lifting for a few years and I've done a few cycles.

Right now I am trying an R3 IGF-1 cycle with MGF.

The question I have is what is the liquid substances in the sachet that iron-dragon sends? Is it BA, BW or AA?

I reconstituted my MGF with BW (bacteriostatic water) I have on hand from Hormone Replacement Therapy (HRT) and that has been going well.

I reconstituted the IGF with the liquid they sent. I filtered it with a whatman filter to ensure it was sterile. So far no infections but it doesn't sting and I heard AA stings.

Thanks for any feedback.

I did E-mail them but they didn't give me a straight answer.
 
Last edited:
Here is some info on how you should have mixed it.

Dilute the IGF-1 with 2mls of Acetic Acid. Assuming (*DO NOT ASSUME*) AA will yield the correct pH balance of your research peptide.
Note: This creates a concentration of 500mcg/ml. So each 1/10 of a ML is 50mcg’s.

Draw the desired amount of IGF in to a syringe. Desired amount should be the approx dose you want to take.
Example- 2mls AA used to reconstitute IGF-1 1mg vial means 5 units on a U100 insulin syringe would equal 25mcg IGF-1
 
Thanks for the reply.

I know how to mix it. I was just wondering if the liquid they sent with it is actually acetic acid. I guess if I don't get any results it is not acetic acid.
 
So far the results are good. It doesn't sting like most people say AA stings.

I ordered some AA anyway and I'll use that on my next vial and see if I can feel a difference.
 
Back
Top