I would bump it to a 1", but I get that a lot too, what helps a bit is leave the pin in for 20 seconds after you shoot to let the muscle absorb the oil
I was going to say the same thing. When done injecting, keep the pin in the muscle for a few seconds before pulling it out. I had this problem a few times and I found this helped somewhat.
Also, if you pull the skin at your inj site and hold it there while you stick, when you pull the pin out (quickly so the juice doesn't follow the needle out) and let go of the stretched over skin, the unbroken skin slides back over the hole in the muscle. Then just hold the alcohol swab on the spot, tightly for a few seconds before rubbing it. Hope this helps.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.