SaVaGe
PowerLifter
My 1st attempt at making test enanthate. Looked clear after I heated it up, but turned cloudy after I filtered. I guess I can bake it and see if it clears up.
I followed these instruction:
Testosterone Enanthate, EQ, Deca
These raw hormones are soluable in oil alone. They need no additional solvents, but for antimicrobial puposes BA (benzyl alcohol) is used.
Items Needed for a 10 gram conversion:
10 grams test enanthate, deca, or EQ
0.80ml benzyl alcohol (2% BA)
31.20ml oil
Syringes 3cc & 5cc or 10cc
20 gauge needles
Mixing vial (or preferably beaker)
Sterile vial
Sterile syringe filter
Weigh out 10 grams of hormone into mixing vial or beaker.
Add benzyl alcohol and 26.20cc of oil. (This will leave 5cc oil for later.)
Place on stovetop (electric stove) or frying pan (gas stove) on medium high heat.
Swirl and heat until soultion is completely homogeneous and clear. NO hormone "swirls" or visible separation should be left.
Place 20g needle in sterile vial and attach syringe filter.
Place another needle through stopper to releave pressure
Draw out hormone solution with 5 or 10cc syringe and run it through the syringe filter until all solution is filtered.
Run the addition 5cc of saved oil from step 2 through syringe filter to purge.
This conversion results in 40ml - 250mg/ml sterile solution for injection.
I followed these instruction:
Testosterone Enanthate, EQ, Deca
These raw hormones are soluable in oil alone. They need no additional solvents, but for antimicrobial puposes BA (benzyl alcohol) is used.
Items Needed for a 10 gram conversion:
10 grams test enanthate, deca, or EQ
0.80ml benzyl alcohol (2% BA)
31.20ml oil
Syringes 3cc & 5cc or 10cc
20 gauge needles
Mixing vial (or preferably beaker)
Sterile vial
Sterile syringe filter
Weigh out 10 grams of hormone into mixing vial or beaker.
Add benzyl alcohol and 26.20cc of oil. (This will leave 5cc oil for later.)
Place on stovetop (electric stove) or frying pan (gas stove) on medium high heat.
Swirl and heat until soultion is completely homogeneous and clear. NO hormone "swirls" or visible separation should be left.
Place 20g needle in sterile vial and attach syringe filter.
Place another needle through stopper to releave pressure
Draw out hormone solution with 5 or 10cc syringe and run it through the syringe filter until all solution is filtered.
Run the addition 5cc of saved oil from step 2 through syringe filter to purge.
This conversion results in 40ml - 250mg/ml sterile solution for injection.
Last edited:
