Aqueous test jams in 25g needle

[Destination230]

Does anyone else have this problem?

I tried diluting it with bacteriostatic water. Didn't help.

I don't understand why this happens. It shoots into the air no problem whatsoever after I pull the jammed needle out. Stick it back in, no go. wtf man lol

 

[appleton111]

It sounds like you’re dealing with an issue related to a clogged needle or syringe when injecting. Here are a few potential causes and troubleshooting steps to help resolve this:

Possible Causes of Clogged Needles and Syringes:​

1. Viscosity of the Solution:
   • High-concentration gear (such as 400mg/ml testosterone) can be very thick and difficult to draw or inject. Even diluting with bacteriostatic water may not sufficiently thin it out if the concentration is too high.
2. Needle Gauge:
   • If the needle you're using is too small (e.g., 25g or higher), it can struggle to draw thick solutions. A larger gauge needle (such as 22g or 23g) can make the process easier, especially for thicker solutions.
3. Needle Blockage or Bent Needle:
   • The needle itself could be partially obstructed, either due to a defect or from a bent tip. If it's been used multiple times, this could also cause the needle to get clogged.
4. Air in the Syringe:
   • If there's air trapped in the syringe, it can cause resistance when injecting, making it feel like the needle isn’t going in properly. Ensure there’s no air bubble in the syringe before you attempt to inject.

Troubleshooting Steps:​

1. Check the Needle Gauge:
   • If you’re using a needle with a smaller gauge (e.g., 25g or higher), try switching to a larger gauge (22g or 23g) to allow easier passage of thick oil-based solutions.
2. Warm the Solution:
   • Warming up the vial can help decrease the viscosity of the oil-based solution, making it thinner and easier to draw and inject.
     • You can gently warm the vial by placing it in warm water for a few minutes (don’t heat it too much; it should just be warm to the touch). Do not microwave it.
3. Ensure Proper Drawing Technique:
   • When drawing the solution, pull slowly and steadily to avoid creating a vacuum that could cause clogging.
   • Draw air first (same volume as the dose), then push it back into the vial and draw the solution. This ensures there’s no air in the syringe that could cause difficulty.
4. Check for Needle Blockage:
   • Inspect the needle tip for any damage or blockage. If you’re reusing needles, make sure they’re in good condition. It may be worth switching to a new, fresh needle if you suspect any blockage.
5. Inject Slowly and Steadily:
   • If you’re injecting too quickly, it can cause the needle to become blocked. Try to inject slowly and steadily to avoid resistance.
6. Consider Using an Oil Filter:
   • In some cases, the oil-based solutions can contain small particles or impurities that might clog the needle. Using a filter needle (or a separate filter) when drawing the solution can help prevent clogging.
7. Try a New Syringe and Needle:
   • If none of the above solutions work, it may be an issue with the syringe or needle itself. Consider switching to a new syringe and new needle to ensure there’s no blockage.

Long-Term Solutions:​

If the viscosity continues to be an issue with your gear (even after dilution), you might consider using a lower concentration product (e.g., 250mg/ml) or looking into the possibility of switching to another ester with a lower viscosity, such as Testosterone Enanthate or Testosterone Cypionate.

If the issue persists despite trying these solutions, it might also be worth seeking advice from a medical professional or experienced individual who’s familiar with injectable steroids to make sure there’s not an underlying issue with the gear itself.