Best tasting oral solutions

AussieThunder

New member
I'm looking to make some very nice tasting oral solutions, if this is possible.
I've noticed that all the recipes around are made with predominantly everclear or 151 and with the possible addition of PEG for some recipes.
Is it possible to make oral solutions with predominantly distilled water once the active has been dissolved? I was thinking about using a small amount of propylene glycol to dissolve the powder, then finishing it off with a mixture of distilled water and flavoring.
In Lozgold's recipes, he states that femara should be made using 10% PEG300
and 90% proof grain alcohol. Would it be possible to to use 10% propylene glycol instead of PEG to dissolve the femara powder, then 90% distilled water and flavoring instead of alcohol? I'm thinking about doing the same with adex & clen. Do you think this would work, or is it really necessary to use alcohol?
Thanks.
 
Alcohol solves most orals and double duties as a preservative. Orals -> bacteria -> not good.

I dont like the idea of using PEG with orals at all. Its just plain unessesary. Want flavoring? Use flavored rum or vodka, or a % mix with grain alcohol and flavored stuff.
 
I've been reading a few other boards & found that femara can dissolve completely in pure glycerin when a bit of heat is applied up to 4mg/ml.
Other people use a combination of propylene glycol and glycerin. PG tastes much better than PEG, aparently. For sweetening and color I thought I'd add flavored cordial. I'd like to attempt making solutions of arimidex (1mg/ml) and femara (2.5mg/ml) by using 10% PG, 70% glycerin and 20% cordial. I'll add the PG to the powder first, apply heat until dissolved, then add the glycerin and cordial.
What do you think about this recipe? Will the PG act as a preservative, or should I add a little BA in there? I bet this recipe would taste nice!
 
DougoeFre5h said:
BA is disgusting beyond simple taste. It like a chemical reaction on your tounge...NOT good.

Ok, well what about BA in small amounts? I'm soon to make liquid clen and the recipe I have calls for 1% BA to dissolve the powder, then 99% water (I'll be using a combination of water & cordial). Do you think this will be ok, or will that amount of BA really ruin the taste of it?
Thanks.
 
AussieThunder said:
Ok, well what about BA in small amounts? I'm soon to make liquid clen and the recipe I have calls for 1% BA to dissolve the powder, then 99% water (I'll be using a combination of water & cordial). Do you think this will be ok, or will that amount of BA really ruin the taste of it?
Thanks.

Bump
 
AussieThunder said:
Ok, well what about BA in small amounts? I'm soon to make liquid clen and the recipe I have calls for 1% BA to dissolve the powder, then 99% water (I'll be using a combination of water & cordial). Do you think this will be ok, or will that amount of BA really ruin the taste of it?
Thanks.
You could mix 1% BA + 99% water and taste it first to test. Then, let us know what you find out!
 
I used grapeseed oil to suspend letrozol, cialis & clomiphine citrate. works fine. Plus I can barely taste anything. The same powders in alcohol taste bad to me.
 
Back
Top