Injection help? Need advice and opinions.

[Hugepecks91]

Hey guys. So lately I was getting infections and shit from injecting due to the fact I was storing needles and then injecting. I think that caused it. But I recently swapped to 2mls every 3 days on injections to avoid that problem. Yesterday I did 2ml of test cyp in my left shoulder and this morning I woke up and I feel like shit. My
Shoulder hurts so bad I can't lift it above my head. It's hot right now to the touch but I did everything fresh and sterile yesterday so if it is an infections
I haven't got a clue how that shit happened. I injected slow and steady to avoid rushing at all, I was fine with no pain at all after the injection and felt great, went to the gym about an hour or do after I did the injection and everything was fine that night with just a little bit of discomfort(pressure) feeling. But It could just be wicked pip. Anyways I would like some advice on if I should try to wait a day or two to see if its just pip or if I should go to the doctor today and straight up get my whites counted. If I don't go to the docs what do you guys recommend to make this rehabilitate faster as far as if it were to be treated as pip.
Lemme know mates

Thanks

 

[bigkit34]

Try running the syringe under warm water to heat.it up 1st. If that dont work grab some bac oil and cut it with that

 

[Hugepecks91]

Try running the syringe under warm water to heat.it up 1st. If that dont work grab some bac oil and cut it with that

what should i do about it right now.. il definately take that advice into consideration for next shot, but i just took 800mg of IB profun to see if that will help cause right now there isnt any swelling or redness.. its just a bit hot to the touch (which could be from sunburn) and hurts like a mother fucker

 

[Hugepecks91]

ok.. now its starting to swell and it looks as if its spreading to the lower portion of my shoulder.. gonna hitthe doctors office now.. jesus christ here we go again =.=

 

[Megatron28]

Tell them it was a B12 shot gone bad.

What are your procedures for injecting? Can you walk through the steps you take?

Is this the first time you have injected into these muscles?

 

[Hugepecks91]

Tell them it was a B12 shot gone bad.

What are your procedures for injecting? Can you walk through the steps you take?

Is this the first time you have injected into these muscles?

Ok. I grab the vials, syringes and alcohol pads. I wash my hands and then use hand sanitizer.
Wash the surrounding area with alcohol
Clean vials with alcohol before opening (the vials are sealed glass 1cc injection)
Wash hands again with hand sanitizer
Open the syringe containers and swap the 18g with the 23g to draw the liquid out
Once the liquid is drawn I swap the heads back
I use alcohol gauze pad on the infected area in a circular motion from the middle working outward
Poke slowly. I go slowly maybe need 2mins for injection since I do 2cc at one time
Wait 10sec before needle withdrawal to avoid oil displacement
When needle is removed I clean area with another alcohol gauze pad and set the gauze pad over the injected site
That's it.

 

[Hugepecks91]

Tell them it was a B12 shot gone bad.

What are your procedures for injecting? Can you walk through the steps you take?

Is this the first time you have injected into these muscles?

I did. Told them it was a b12 and stuff and it was cool. Got some anti biotics. Hopefully this will go away. This isn't the first time I have had an infection. And this is my second cycle. I'm doing test only again for now until this calms down. Then later I'll introduce tren and masteron. But this shit has
To stop first.

 

[bigkit34]

30sec per ml is fine 1 min seems kinda drawn out lol. Seems like ut just has a high ba content you seem to take sterility precautions

 

[MustangDX]

I use a 25gx1 pin for my delts and I use the 23gx1.5 for my glutes. I know the gauge size didn't cause the infection but maybe think about moving to the 25g for your delts. That's what most AAS users use for that body part.