No blood after pin a problem?

NarcisPrince

New member
I have pinned my friends (glutes, quads, and delts) and there was normally a bit of blood each time.

I am only through week 1 (500mg/w Test-E) and 2 pins, but both times there was no blood whatsoever (yes, I always aspirate). I just wanted feedback as to if this could be because of:

A. It going subq (should still absorb, but slower correct?)
B. Because I use a 25 and the puncture is small
C. Just depends on the person

Thanks for feedback, much appreciated
 
No blood after an injection is a good thing. Usually if there is blood it is because you went thru a vein on the way in.
 
Yes no blood is a good thing, and 25g is prefect for injection this is what I use, in the future I may try smaller gauge. Also as noway55 says pulling the skin when injecting will not let the blood or gear come back out when pulling out with the needle.

Also keep a alcohol pad on the site after pulling out for about 30 sec's, because if it does bleed you do not want to lose gear.
 
Last edited:
Thanks fellas. Better safe than sorry, and because I had swelling I hoped the non-blood factor didn't play into that. I'm sure it's just virgin muscle or high BA from it being UGL.

Appreciate the responses, and the pull skin technique.
 
Yes no blood is a good thing, and 25g is prefect for injection this is what I use, in the future I may try smaller gauge. Also as noway55 says pulling the skin when injecting will not let the blood or gear come back out when pulling out with the needle.

Also keep a alcohol pad on the site after pulling out for about 30 sec's, because if it does bleed you do not want to lose gear.

using alchohol on a open wound will prevent blood from clotting properly and can cause brusing.
 
I consider it a sucessful pin when no blood comes. I've only done one cycle but I see a correltation to PIP and how much I bleed. No bleed=no pip for me. At least this is what I've convinced myself of
 
Back
Top