Pinning advice

[matz951]

Hello, well I recently started my test e cycle on the 1st, I have 5 cycle's under my belt, and its been a while since I cycled. Well getting to the point, on thursday I shoot 1cc of test in my delt using a 23g 1.5" pin, what I usually do is go in about 1.25" and push the oil in slowly for example I will push in about .20cc's then wait 15 seconds then push another .20 until all the oil is in, then I'll pull the pin out slowly about .5" wait 15 seconds and repeat until its out. Well I seem to have lost my touch as the last 4 times I pinned oil always dribbles out and I mean lots of oil. So any advice would be appreciated on how to stop this or techniques you guys use.
Thanks in advance.

 

[Trevdog]

I've never had an issue with that but some people sort of pull the skin from the side before putting in the pin, hold it like that while they shoot, then after they shoot they pull out the pin, release the "pulling" action, and supposedly the skin moves back kinda over the little pin hole, preventing spillage.

Maybe next time you want to try 25 gauge pins. They are better for comfort and minimzing scar tissue. They do take longer to push oil through.

 

[matz951]

I've never had an issue with that but some people sort of pull the skin from the side before putting in the pin, hold it like that while they shoot, then after they shoot they pull out the pin, release the "pulling" action, and supposedly the skin moves back kinda over the little pin hole, preventing spillage.

Maybe next time you want to try 25 gauge pins. They are better for comfort and minimzing scar tissue. They do take longer to push oil through.

Alrighty I'll try that, thanks for the advice to.

 

[Greazy-Pickle]

z injections and 25gauge pins.. 25g 1inch is plenty for most delts.. and the smaller pin forces a slower injection this way you wont have to stop and wait.. if you dont know a z injection is what TREVDOG was explaining..