Problem with delt pinnning!

[blaken4]

I used a 23/g 1 1/4 inch needle to pin my right delt.

it's 250mg/1ml of test.

put the whole needle in, after taking it out some of the test came out the needle hole so I applied some pressure for 10-20 seconds then it stopped.

2 days later it's like the test has "ran" down my arm a bit and my arm is slightly red/sore in the outer tricep/bicep area but it's not in the muscle.

This is happened to me before in the left delt and it went away after a few days.

Firstly how do i stop this from happening and secondly how bad is it?

 

[dialtone]

you're fine. Heat up the gear before you inject next time.

 

[blaken4]

Was thinking about that, definitely will do next time thanks.

 

[MeatHead96]

I would use a 25g 1" for delts. Personally I use 29g slin pins .5". Works well for me. Hold the needle in there for at least 30 seconds post injection before removing it. Then put an alcohol swab on it right away and massage the area.

 

[weights=life]

i used 21 guage for all my pinning in delts and only had that problem once. but its all good...ill be using slin pins next cycle.