question of reconstitution of tb500

[sancio]

i find it hard to reconstitute the tb500 that comes in 2mg lots,i used 0.2ml of bac or 2units,only to be able to draw 0.16ml or 1.6 units.that is a loss of 20% of the product in my eyes.should i use 0.4ml to reduce the actual loss to only 10% or is there a known way to get the whole lot out?
appreciate your feedback guys
(ps:was using 1ml 29gage pin for procedure)

 

[Pittsburgh63]

I use 1ml of BAC with 2mg peptides.. Gives you 100mcg's = 5iu's. Much easier to deal with. I almost always split the mg's in half with BAC. 5mg I'll use 2.5ml.. gives you the same 100mg's = 5iu's.

 

[sancio]

I use 1ml of BAC with 2mg peptides.. Gives you 100mcg's = 5iu's. Much easier to deal with. I almost always split the mg's in half with BAC. 5mg I'll use 2.5ml.. gives you the same 100mg's = 5iu's.

that may be correct with cjc or similar,but as far as the tb500 is only one injection it is a lot to use a full ml in my opinion

 

[Pittsburgh63]

Not really.. when using AAS, which is an oil, I use 3ml+ at one time. 1ml of BAC is nothing.

 

[sancio]

Not really.. when using AAS, which is an oil, I use 3ml+ at one time. 1ml of BAC is nothing.

sure thing,but IM is a bit different then SC isn't it?i always thought you should keep it as low as possible specially for SC

 

[Pittsburgh63]

I would be using the TB-500 IM as close to the problem area as possible.

 

[pharaoh]

Supposed to use sodium chloride .9 on tb500

 

[Pittsburgh63]

Supposed to use sodium chloride .9 on tb500

Correct.. Sodium chloride is best suited.

I've used BAC as well with no issue.