Questions on front loading

DDTexas

New member
Planning my second cycle:

33, 6'6", 250lbs 15% bf
10 weeks, want to go big for a shorter length of time
750 test 3 broken up by 375 2x a week
400 EQ (Maybe Higher dose???)
500 HCG 2x week
caber on hand
50 mg Dbol weeks 1-5
nolva/clomid PCT 3x weeks after last pin

Want to front load my test e and EQ-going to go with 1400 test e and 800 EQ. Do I pin on the first day of my cycle then wait until the second week and start my normal 2x a week pins? Or do I front load on day one and then just wait a few days to start my cycle? For 1400 test e, would be 2x injections of 3ml-most I've ever done at once or in ml. Should I do them the same day, or break it into two days? Plus the EQ-should I pin that on the same front load day as my test e? Would be 4x pins in one day! Doable, just want to make sure I'm not going to over load my system.

Lastly, with the HCG, if I pin my test/EQ on MON/FRI is it ok if I do HCG on TUE/SAT?

Thanks for the help!
 
If you're not on TRT it doesn't matter much with the timing of the HCG. Just pin it with equal time between pins.
 
Your eq dose is pretty low. Imo why wouldn't u use short esters for a ten week cycle? Running eq for ten weeks especially that low of a dose is a waste. I would run test prop and npp.
 
Yes 400mg EQ is a bit on the low side, I'd run minimum 600mg. Not only that, but EQ will take 10 weeks for it to really have much effect, it is a very long ester and there would be more suitable options for a ten week cycle, as mentioned NPP comes to mind.
 
Back
Top