A very indepth article on MT2 tanning peptide


New member
Melanotan 2 or MT2*Protocol**

Low Melanotan 2 dose: 250 mcg*
Typical Melanotan 2 dosage: 500 mcg*
Large Melanotan 2 dose: 1mg*

Add 200 units (2ml) of water to the vial. 2ml/200 units will minimize the volume that you have to inject and will simplify the arithmetic in your MT-2 experiment. Dosing measurements are often mentioned in both milligram (mg) and microgram (mcg). Example: .5mg =500mcg**

Needles and syringe*you will need**

1ml syringe (U100), 2ml BW to reconstitute**
Calculations for a desired *dose:*
Step 1= 10mg vial MT-II*
Step 2= 2ml bac water**
Step 3= 500mcg*dose*
5 ticks on your insulin pin*

http://peptidecalculator.com/calculator.html* to work things out further if you want to change the volume of Bac water**

Starting dose:*Your first injection should be a very small dose, for example .25mg (250mcg). See how you react. Goal should be to feel nothing. Dose after dinner, before bed. Any dosing chart stating that you should take a high dose (according to your weight) is outdated and potentially dangerous.*****65279;

Loading dose:*Load with 0.5-1mg once a day. People who have used doses in this range generally r***65279;eport getting excellent results. Don’t worry if you miss occasional days. It will not make much difference, focus on the cumulative effects.*

Maintenance dose:*Maintenance is taking doses less frequently than daily to avoid becoming darke***65279;r than you want. Yes, that will happen. With enough UVR, you will get much darker than you have even been before. A maintenance dose can help prolong super-physiological photo-protection MT-2 delivers.

Storage:*Store unmixed in the fridge and mixed in the freezer*don't*freeze the*reconstructed*vial **

How to mix**

So to simplify things**
10mg vial add 2ml of bac water first starting dose 250mcg draw to tick mark 3 or 5iu i do this before bed in case i get flushing and*sick*feeling..*If you feel you get the sicky feeling with MT2 get some travel sickness tablets from Boots and take one 30 min before the jab this will ease it a bit ..**

Now you know your ok with that dose start the loading phase 500mcg tick mark 5 or 10iu pre bed unless you want to*suppress*your*appetite*then inject in the morning ..Now run it at this dose till you reach the*colour*you want ..Dont forget to tan twice a week to get nice and brown ..10 min is max start on 5 this might sound low but you will be*susceptible*to burning till you have built up a*tolerance . Run this till you reach your*desired*colour***

Maintenance*dose*i find 500mcg once a week with a tan of 10min every 7 days will keep my tan*topped*up nicely**

Storage*..draw the MT2 from the vial and load up about 40ish syringes*normally*then put in a tub and freeze ..when you need to do your jab remove one syringe leave on the side for a few*minutes*or hold in the palm of your hand ,,*
How Often to Tan on Melanotan II*

The tanning activity of Melanotan II without the need for UV exposure has been proven by clinical trial; however, the majority of users report that results are achieved much quicker, and that the tan is a more natural color, when Melanotan II is combined with a small amount of UV exposure.

Loading:*Tanning should start after the third injection and occur 2-3 times per week if you wish to see tanning results quickly; otherwise one tanning session per week is sufficient to gradually build your tan.Maintenance: Skin types 1 & 2 usually need one tanning session per week to maintain their tan. Skin types 3 & 4 often find they can maintain their tan with Melanotan II injections only, however, if you find your color fading then you should go tanning once per week.Things to remember:

If you are not seeing results then you need to increase the frequency of your outdoor or indoor UV exposure (especially if you are skin types 1 or 2). Never increase your recommended Melanotan II dose.*
Tanning sessions should be short, 5-10 minutes in a sun bed or 30-40 minutes in the sun on a warm day is sufficient each time. DO NOT overexpose yourself to UV rays.

When starting, always use 30+ sunscreen on sensitive areas such as the face and neck. Because these areas are frequently exposed to UV rays they are more responsive to the melanin producing effects of Melanotan II and therefore will become darker quicker than the rest of the body. Covering these areas initially will allow other parts of the body to tan first, ensuring you achieve a well balanced tan.*
Melanotan II and UV exposure complement each other, so if you spend a lot of time tanning you will need less frequent injections of Melanotan II to obtain and maintain your tan. If you don't spend much time in the sun or sun beds then you will need more frequent dosages of Melanotan II to develop and keep your tan.*
Skin Types*

The frequency of Melanotan II injections will depend largely on your skin type to begin with, therefore you should identify with which Fitzpatrick skin type you are:*

Type 1:*Pale skin, many freckles, blue/green eyes, red hair, never tans, always burns*
Type 2:*Fair skin, few freckles, blue/hazel eyes, blonde/sandy hair, tans poorly, usually burns*
Type 3: Darker white skin, brown hair/eyes, usually tans, rarely burns*
Type 4:*Light brown skin, darker brown hair/eyes, tans easily, burns minimally*
Dosing chart for your weight that is now out dated*(just for*reference)*
Weight*Melanotan II dosage*Amount to inject (ml)*Injections per vial*
50kg or less*
0.05ml (“5” on syringe)*
20 doses*
0.06ml (“6” on syringe)*
16 doses*
0.07ml (“7” on syringe)*
14 doses*
0.08ml (“8” on syringe)*
12 doses*
0.09ml (“9” on syringe)*
11 doses*
100kg or more*
0.10ml (“10” on syringe)*
10 doses*

Using MT2 to treat*sleep*disorders*http://www.ncbi.nlm.nih.gov/pubmed/22171046*