guys I need some quick help.

[young-gunz21]

hey guys sorry for asking but i have some masteron homebrew that someone else made (a good friend),however it is clumpimg a little on the bottom it is crystalizing i think do i heat this stuff up with a pin in the top to drain off the pressure and this will go away? any suggestions brothers.

 

[tman55]

hey guys sorry for asking but i have some masteron homebrew that someone else made (a good friend),however it is clumpimg a little on the bottom it is crystalizing i think do i heat this stuff up with a pin in the top to drain off the pressure and this will go away? any suggestions brothers.

that is what i would do.

 

[young-gunz21]

ok im gonna go for it trhanks bro i dont know to use the pin or not cause it is half empty anyway

 

[tman55]

ok im gonna go for it trhanks bro i dont know to use the pin or not cause it is half empty anyway

i would use the pin just in case too much pressure builds up

 

[Stone]

Just heat it lightly on the stove with the pin head above the oil, and as soon as it goes back into solution you can take it off the heat. You don't want to heat it too much or else you may damage the hormone (don't worry about this though as it must get pretty hot, just keep an eye on it).

 

[BigRonWannabee]

i would use the pin just in case too much pressure builds up

You only need to quote someone when your NOT the next poster to respond. Yellow flag.

 

[Stone]

Dougoe don't mess around when it comes to keepin the board effecient.










































Seriously.