howieg said:
i have been doing test 300 and trenbolone 100 for about a week and half now i started with half cc now ,on monday i did a full cc of test and tren... i put both se's in one saringe and then shot 2se's of the mix in the ass now its all swolen up bad and red? help please should i shoot the test and tren in diff places?
First of all you need to get the infection taken care of before injecting in that area again. Once that is done here is a detailed instruction for IM injection:
PREPARING FOR SELF-ADMINISTRATION INJECTIONS:
1. Wash hands thoroughly with soap and warm water.
2. Select a well-lit, clean hard surface preferably with a mirror (e.g. Bathroom countertop).
3. Ensure you have all necessary supplies and that all packaging and wrappings are intact and there are no signs of tampering. Double check the expiration dates on all medications. NOTE: With Testosterone (Intramuscular injections) You will use (2) two needles: (1) one needle for drawing the medication, referred to in these instructions as the "drawing needle" and (1) one needle for administration of the solution, "administration needle". (I use two needles but you do not have to. If you have a hard time giving yourself and injection then this is a good idea because it goes in so much easier)
DRAWING SOLUTION INTO SYRINGE:
1. Use alcohol wipes to clean the tops of the vials - move in one direction and use one wipe per vial.
2. Remove syringe with needle from packaging and fill syringe with an equal amount of air as the intended dose by pulling plunger back to the desired mark (i.e. If you are drawing up 2 ml's of solution you would pull plunger to the "2" on the syringe).
3. Insert the needle straight through the rubber stopper, into the vial. If you touch the stopper with your finger clean it with a fresh alcohol wipe prior to withdrawing medication.
4. Turn the medication vial upside down keeping the needle tip inside the liquid.
5. Inject the air into the medication vial. This helps to maintain a balance of internal/external pressure when using glass vials; this also makes future medication withdrawal easier.
6. Hold the vial and syringe in one hand and slowly draw up that amount of liquid into syringe.
7. While holding the vial upside down and maintaining drawing needle inside the vial, gently tap the side of the syringe until air bubbles rise to the top of barrel of the syringe. Gently push the plunger to eject ONLY THE AIR BUBBLES through the needle.
8. Remove needle and syringe from vial.
9. Recap needle by placing the plastic needle cap on countertop and safely guiding the needle into the cap. This reduces the possibility of accidentally sticking yourself.
10. For Testosterone and/or IM injections remove the drawing needle and discard it in an OSHA approved Sharps container. Federal Regulations require needles and sharps objects to be disposed of in
INJECTING OF SOLUTION:
Keep syringes and materials clean and do not let anything touch the tip of syringe or needle. If you accidentally touch the tip or accidentally contaminate it in any way you must discard and start all over. This eliminates the possibility of infection.
1. For Testosterone or IM injections Remove fresh administration needle from packaging and inspect for any defects. Do not remove plastic cap until ready for injection.
2. Firmly twist administration needle on to syringe and maintain in front of you on countertop until you are ready for administration.
3. For SUBQ injections the small insulin syringe is preloaded with needle which cannot be removed and will be used for administration.
4. Use an alcohol wipe to clean skin at the injection site; let it air dry. Throw away the wipe. NOTE: Do not use any areas in which you feel lumps, bumps, firm knots or pain. Do not use any area in which the skin is discolored, depressed, scabbed, or is broken open.
5. Remove the needle cap from the needle and gently pinch the skin together around the site (to lift it up a bit). The best areas for injection are away from joints, nerves, bones, and other important body structures. NOTE: The preferred areas for Intramuscular (IM) injections, such as Testosterone, are the gluteus maximus area or quadrisect. Note: If injecting into the quad divide you leg in half. From the center line move slightly to the right (for right leg) .
6. With a swift motion stick the needle into the skin at a 90° angle for intramuscular (IM) injections.
7. (IM) While needle is in the muscle pull back on the plunger slightly and look for blood inside syringe. *Rarely will there be blood but if you experience this - it just means you are near or hit a blood vessel. Immediately pull needle and syringe out and gently massage area with gauze or clean tissue. Discard the needle and Go back to Step 2 in this section and repeat after selecting another injection site.
8. Inject the medication by using a slow steady push on the plunger until the syringe is completely empty. Hold a cotton swab or gauze near the injection site.
9. Swiftly and safely remove the needle from the skin and gently massage the injection site with a dry cotton ball or gauze. Wipe injection with alcohol pad and apply bandage if needed.
10. Immediately discard the syringe and the needle in an OSHA sharps container.