Hi all, I posted this on a few sites already, so just copy and pasted. Here it is:
"I have never really experienced a whole lot with Primobolan in the past. Recently, I did a 10g conversion at 2/15. I thought that would be enough BB as I have read nothing but success with Primo 200mg at 2/18. I have crashed cyp in the past fixed no problem and have never had another problem since trying Primo. 2 times now. Imagine a hand full of cotton balls diluted in oil at the bottom of the beaker, and that is what this looks like. Is there a step somewhere I may have missed? Below is the what was used.
10g powder "primo" @ 100mg/ml / 100ml to make
2ml ba
15ml bb
75ml cottonseed oil
In beaker in boiling water. The beaker is raised approximately 1/2" above the actual heat source. So, no direct heat to the glass. Boiled until the ingredients mixed. I checked the temp and it was at 189 degress F. I kept the at approx 190-210 in the over and put inside oven for a bit. I know for a fact the temp did not surpass 210.
I let cool before filtering. During the filtration process is when it started to crystalize. Started on top of the actual membrane of the filter and inside the rubber hose. "used a stericap". Then looked over the entire project and noticed it was happening everywhere. Including the filtered side of primo was "spider webbing"? Thats the only way I can think to explain it. If there is a step or trick of the trade someone is willing to share, I'd be greatful. Thanks for you time fellas"!
Best Regards,
AP
"I have never really experienced a whole lot with Primobolan in the past. Recently, I did a 10g conversion at 2/15. I thought that would be enough BB as I have read nothing but success with Primo 200mg at 2/18. I have crashed cyp in the past fixed no problem and have never had another problem since trying Primo. 2 times now. Imagine a hand full of cotton balls diluted in oil at the bottom of the beaker, and that is what this looks like. Is there a step somewhere I may have missed? Below is the what was used.
10g powder "primo" @ 100mg/ml / 100ml to make
2ml ba
15ml bb
75ml cottonseed oil
In beaker in boiling water. The beaker is raised approximately 1/2" above the actual heat source. So, no direct heat to the glass. Boiled until the ingredients mixed. I checked the temp and it was at 189 degress F. I kept the at approx 190-210 in the over and put inside oven for a bit. I know for a fact the temp did not surpass 210.
I let cool before filtering. During the filtration process is when it started to crystalize. Started on top of the actual membrane of the filter and inside the rubber hose. "used a stericap". Then looked over the entire project and noticed it was happening everywhere. Including the filtered side of primo was "spider webbing"? Thats the only way I can think to explain it. If there is a step or trick of the trade someone is willing to share, I'd be greatful. Thanks for you time fellas"!
Best Regards,
AP