measuring 600mg of test e

jkowal99

New member
I have some test e 250mg/ml - 10ml vials. If I want to measure 600mg into a 3cc/mL syringe, would that be right around 1.2 ml in the syringe? thanks
 
Approx, the only way to be 100 percent accurate is to use slin pins and do more frequent injections IM in lean areas.
 
^^^Agree, slin pins are the most accurate/you waste the least. BUT, you can get pretty accurate if you know what you're doing with a regular 3cc syringe. Also, if you get alittle extra(which i usually try to error towards) or alittle less, its not gonna kill you...doubt you'd even notice a difference.
 
^^^Agree, slin pins are the most accurate/you waste the least. BUT, you can get pretty accurate if you know what you're doing with a regular 3cc syringe. Also, if you get alittle extra(which i usually try to error towards) or alittle less, its not gonna kill you...doubt you'd even notice a difference.

That was going to be my next question. I didn't think being just a little over or below would be a problem. Thanks guys.
 
I have some test e 250mg/ml - 10ml vials. If I want to measure 600mg into a 3cc/mL syringe, would that be right around 1.2 ml in the syringe? thanks
Must be awhile since you took grade 5 math
1ml @250/ml= 250
2ml@250=500
3ml@250=750
600mg@250mg/ml =aprrox2.4ml
 
Must be awhile since you took grade 5 math
1ml @250/ml= 250
2ml@250=500
3ml@250=750
600mg@250mg/ml =aprrox2.4ml

Drawing to 2.4ml into the syringe seems a bit much. i dont think that's correct. I did the math and drawing to around 1.2mL was what I calculated.
 
Ok, either way, if your wanting to inject 600 mgs total and it is 250 mg/ml, then you would need 2.4 mls. If your vial has 300 mgs per ml then you would need 2 mgs/ml. A ml/cc is the same thing.
 
Personally I don't think you'd notice the difference between 600 and 750 if the math is so hard, pull 3cc's. And if each injection is somewhere between 1.25 and 1.75 (within 1/2 cc), I think you're probably going to be close enough for government work.

Pay attention to sterility and gett the injection to the right depth (so many bros missing injections these days). Don't sweat 100mg of e. With the ester that's more like 66mg anyways.
 
Drawing to 2.4ml into the syringe seems a bit much. i dont think that's correct. I did the math and drawing to around 1.2mL was what I calculated.

Another one who has math issues...lol...perhaps its guys like you are the one who complain about underdosed gear....and it turns out your underdosing yourself and the gear is fine...lol
 
Another one who has math issues...lol...perhaps its guys like you are the one who complain about underdosed gear....and it turns out your underdosing yourself and the gear is fine...lol

no need for being a douche. i clarified my mistake, get over it.
 
Some of you guys make me laugh. Its obvious that if he wanted 600 mg's and his math came to 1.2 cc and your math came to 2.4 cc thats 1.2 x 2 pins a week ( very standard practice) = 2.4. Im sure you could have figured. That out without being a tool
 
Back
Top