nandrotest 500,, anyone tryed this???

I heard and see in UK... Bad rep!

If i remember well it was sorness as hell and the users couldn't inject it...

but not other fedback.
 
Ethyl oleate. some steril oil... i think researology has something to help it this way.
 
is that a test/deca mix? it sounds like a good idea, are there any down sides to mixing compounds like that?
 
is that a test/deca mix? it sounds like a good idea, are there any down sides to mixing compounds like that?

Not new sides... deca-sides and testosides.

that mixed stuff is a good idea in test deca cycle to make less frequently injects, while ther's one ml which contain both.
 
the only down side i know of is it hurts like hell for a day after the jab .. but if i warm it up a little it flows in no probs and not that bad,,
but everything is on the up tho seams to be working a treat,,, :naughty:
 
can you be a little more spcific to the consistency of the nandrotest in the vile. I have some and it looks really thick and gloopy at the bottom , almost jelly like.
it tends to disperse back to a liquid when you shake it.
Does this sound ok to you guys?
 
can you be a little more spcific to the consistency of the nandrotest in the vile. I have some and it looks really thick and gloopy at the bottom , almost jelly like.
it tends to disperse back to a liquid when you shake it.
Does this sound ok to you guys?

my test had same problem.. put it in some boiled water for about a minute or so. it cleared up perfectly and never happened again.
 
thanks powerstroke. I will give it a try.

hi, mine was the same i warmed it up and used a 1 mil, of tren and a mil of nandro i wouldnt use more then that as it is still very thick, i put the tren in just to soften it up a bit,,,,
 
My Nandrotest 500 had the same prob if it wasnt kept at room temp, you can just warm it up in warm water or keep it in the airing cupboard to warm up. When it gets too cold the gear tends to separate from the oil, so just remember, don't leave it get too cold. Plus by warming it prior to injection its a bit easier to inject as its at little thinner warm.
I wouldn't worry too much as long as you look after it mate.
 
Back
Top