Needle size with test cyp

[Southernfish]

You don't know pain until you shoot your biceps with a 21g

the worst injection ive had was a bicep injection, fuckin brutal.

 

[HardGainer87]

I use 25g. Doesn't seem to take very long for me. I may try out the 29g for trt whenever I slim down.

 

[skillhill]

I used a 20 one time because it was all that I had. It was a Sus rediject and surprisingly it really didnt hurt. Must have really hit the sweet spot!! 22-23 are good imo if you have the patience and a steady hand.

 

[Wolffe]

depending on your state you may be able to go to your local walgreens and get them from there in ny you can buy 10 per day at any local pharmacy if not online.

 

[aag22]

I used a 20 one time because it was all that I had. It was a Sus rediject and surprisingly it really didnt hurt. Must have really hit the sweet spot!! 22-23 are good imo if you have the patience and a steady hand.

I started out using 20g. I like them and 21g because of how fast the inj goes but will try the 22 and 23 because I'm worried about scar tissue. One more question, is a 1in plenty for quads? I don't carry much fat there

 

[LetsGoHeavyBro]

I use 23g 1in .. For my cycles.. Same needle to draw and inject and I've never have had any problems..

 

[jack3d4life]

I started out using 20g. I like them and 21g because of how fast the inj goes but will try the 22 and 23 because I'm worried about scar tissue. One more question, is a 1in plenty for quads? I don't carry much fat there

If you're pretty lean 1 in is fine for quads bro.

 

[Norsegod]

One inch is more than enough. As long as you aren't at like 20% bf.

 

[Wolffe]

1in should do it

 

[snowpatrol123]

I started out using 20g. I like them and 21g because of how fast the inj goes but will try the 22 and 23 because I'm worried about scar tissue. One more question, is a 1in plenty for quads? I don't carry much fat there

For quads, 1" is fine if you're lean. I used a 5/8" a few weeks ago and regretted it though. Fine for delts and ventroglutes, bad idea in my quads at least.

 

[Optimal]

I've only done 25G but I see no reason to switch. Barely feel it (even less than slin pins, oddly) and I think it's better to plunge slowly anyway, seems to helps avoid the PIP imo.

lol. Man, I will tell you. Out of desperation one time, I was wanting to start a cycle so bad. My needles were going to come in 2 days. I was sitting there looking at the test on my dresser. I had 2 18 gauge pins. I decide to draw out 1.5ml and then put a fresh 18g top on. I injected right in my quad. Never again. Hurt like a bitch and I bled like a stuck pig. That 18 gauge taught me patience that day. I will wait a month for slin pins before I ever think to pin myself with an 18g again. Lol.

Hahaha, that sucks but pretty funny man. Could totally see myself doing that.

One inch is more than enough. As long as you aren't at like 20% bf.

20% BF here... yet no fat on quads, still very visible insertions. Wtf genetics... my arms & ass are obese

 

[hunnster]

23 or 25

 

[hunnster]

I've had to use very big ass needles because of cold and thick liquids and it just hurts a bit more.. Try to use as small as you can