pre loading darts.

[vondameon]

Is it O.K. to pre load gear in a synrige a few days before use? It makes it easier to load darts a few days ahead of time and have it ready to go for Sunday in case there are too many poeple around. This way I can get in and out of the bathroom without anyone noticing. Gets hectic sometimes.

Any problems doing this? Thanks.

 

[kube]

sterility. make sure you change the needles after loading to reduce the risk of any contaminants getting onto them. and put the syringes back into their plastic pouches and seal them off with tape. and make sure you clean the area where you do the loading. i recommend spraying some lysol on any surfaces and into the air while you do this. i know it sounds like alot but you dont want to risk getting an abcess due to infection. thats all i can think of. later.

 

[dirty-dog]

what kube said...i have preloaded darts and fed'exed them places - there is some leakage but it's minimal.

 

[vondameon]

Thanks guys. I appreciate the quick response. I will take those precautions you've mentioned. Thanks again.

 

[kube]

i forgot to mention if you have an oven, just crank that bitch up until it gets really hot. open the door and clean it off really well, then do everything i said earlier on top of the open door. the heat destroys any bacteria floating around in the air and repels whatever airborn contaminants are around. basically, hot air pushes away cold air and anything in it.

 

[That-Guy]

kama to cube