Question

[Wizdom88]

If you preload your syringes do you increase the chance of infection?

I have a bottle of t300 and to keep a long story short I knocked the rubber stopper out. If I preload all the syringes now with 1ml (300mg) will it stay sterile until I inject? Is there a trick to this or should I just buy a new bottle?

Also how well does bacteria thrive in test oil?

 

[tbonexl]

I've done it before without a problem..

 

[Rida5d]

No prob with that . Keep the syringes protected with the needle covered.

 

[KingBF]

just tilt the needle head up so oil dont leak out. i put mine in sandwich baggies. dont know if it helps but it makes me feel like it does

 

[hardtarget]

Keep the syringes in a clean place with the needle covered. I would pre-load a week supply at a time max.

 

[Nightmare007]

If its done in a sterile environment there's no to very little risk of infection

 

[D-Town]

I would preload those pins. The chance of the open ended bottle getting knock over
is risky. If the needles are sterile, then you have new environments for your gear! Place them
in a bag if you wish, and needle side up out of the way. Happy pinning!

 

[JM750]

just tilt the needle head up so oil dont leak out. i put mine in sandwich baggies. dont know if it helps but it makes me feel like it does

This is your answer.

 

[Wizdom88]

Thanks for the advice boys. This is my first cycle. So far with a lil pip and by a lil I mean "for fuck sakes" things are going well.

I'm running t300 for 4 weeks to build quick ester then ill continue for 10 weeks with test e 250mgx2 mon thurs.

I should start a new thread detailing progress.

 

[Boltbreaker]

Your good just cap em and keep in a bag sealed till you pin em..