Reconstituting LR3, need measuring advice.

[Jeter]

Ok, so I screwed up my first batch of LR3 and reconstituted with only .9% Sodium Chloride. Found from a source that if you do that its only good for one pin. So that got trashed.

Ordered a new bottle of 1mg 1gf-lr3 (lyophllized). I have 1 bottle of sterile water distilled with 5ml with 0.6% acetic acid. I also have one empty 10Ml sterile vile. I have two different syringes both are 29 guage. The first one is .5cc/ 1/2" and the other is 1cc/1/2" (which I have a bunch more of). I understand this time I am not going to use the .9% Sodium Chloride until prior to pinning to take the sting out of the acetic acid. I also understand that I have to some how get 1ml or 2ml of the acetic acid mixed with the 1mg lr3. When adding I know to add slowly so runs along the sides.

Now this is where I am lost. First based on the syringes I have I am not sure how much of the AA do I withdraw and mix with the LR3. Also I do not think it (1ml AA or 2ml AA) will fit in the small bottle of the LR3, it may I am not sure, but I have this empty 10Ml sterile vile.

So I obviously need some help with measuring this out exactly with what I have so I can't screw this up for the second time. I just took it all out and was ready to mix and tried to follow advice from other posts but want to be definite before I proceed further and make another mistake. I need to do this asap, so please type back. I never pinned before and I am retard to math so please with what I stated above help me out so its retard proof. THANK YOU!!!

Also once I have this mixed correctly how do I know what measurement to take out using these syringes...

 

[tnemo]

Use BA water to reconstitute
Put 2ml in the bottle should fit (this is if you have 2mg IGF)
then each tick is 10mcg
Take 60mcg/day

 

[Jeter]

I have 1mg of 1gf Lr3 that is (lyophllized), its in a powder form about 1/4 up in the vile. Not sure how many ml of AA will fit in it. I would think 1 ml should. If 2 ml didn't fit, I thought maybe I would take that entire amount out 1ml mixed with 1mg of the IGF and put into the larger empty vile that I have and then add another 1ml of AA. I have read other posts but from the syringes that I have not sure what is the proper amount to withdraw from AA that I have. Also not sure if there's a special measurement of the AA since its 1 bottle of sterile water distilled with 5ml with 0.6% acetic acid. I am over paranoid, its not cheap, and want to make sure I get the correct doses.

 

[Four1Thr33]

Just FYI. There's a peptide calc in the peptide section I this forum. It's a great help

 

[Jeter]

Help

Somebody else please provide a little more in detail on actually answering the ?'s that I asked. I been wanting to cycle on this for over a month now. Please just take a few and let me know what I need to do. Thanks.

 

[Four1Thr33]

Ok I'll say my facts again.
Step one: go to our peptides section
Step two : click the peptide calc
Step three: add info
Step four: mix peptide
Step five : inject