Chem Tech 600Mg of Test per ML :/
- Thread starter copaseet
- Start date
Onk
1kg = 2.20 lbs
no.
test 400 usually involves 175 cyp, 175 enth, 50 prop.
you can also have sust 500 which I've seen at 100 e, 100 c, 100 pp, 100 i, 100 u
So I'll assume it may be done....may be unstable or not, but probably hurts like a mother fucker.
Using the above method of 4 esters I've seen eq at 400mg/ml and deca at 400mg/ml....which breaks the usual convention
test 400 usually involves 175 cyp, 175 enth, 50 prop.
you can also have sust 500 which I've seen at 100 e, 100 c, 100 pp, 100 i, 100 u
So I'll assume it may be done....may be unstable or not, but probably hurts like a mother fucker.
Using the above method of 4 esters I've seen eq at 400mg/ml and deca at 400mg/ml....which breaks the usual convention
luckypaul
New member
I had to use 18% bb to disolve 250mg of cyp /ml. I brewed some 500mg/ml test u about 10 years ago and there was very little room for oil after adding solvent. You can use EO as the carrier which will allow a higher concentration, but alot of people have a bad reaction to it, myself included. I would not buy t600 or t500. 200mg of test deconate and 200mg of test e is okay for t400. They both disolve easy, but I don't buy throwing test cyp into the mix.
halfwit
I like turtles.
Possible? Yes. Some godawful pain in a pin? VERY likely. As Paul mentioned, it requires a TON of solvent to keep it from crashing, which gives it some serious bite. The undecanoate ester would make it a little less angry than if that were prop, but I'll take 2ml of 300mg/ml in a pin over 1ml of that lava any day.
Similar threads
