Difficulty in pushing the syringe

[net4sat]

guys I use 2ml syringe 22gx1.4

the problem is I cant push the oil at syringe

what wrong

I use 5ml syringe also but same problem

there is syringe to use by oil based injectable?

 

[balboa270]

I always pull all the way and push and again to lossen tube no pun intended so its not so hard to inject

 

[DADAWG]

use slow steady pressuer , its not supposed to come out fast .
heting the oild slightly can help , ive seen people load the syringe and hold it under warm/hot running water to warm it but be carefull not to get anything but the barrel of the syringe wet for sterility reasons.

 

[balboa270]

OOr ya got some rubber in there

 

[MeatHead96]

I heat mine with a blow dryer for about 30 seconds before pinning. Idk why you would have issues with a 22g though. Thats a pretty big pin.

 

[net4sat]

WTF this!!! I don't understand anything

there is syringe to use by oil based injectable?

 

[DADAWG]

WTF this!!! I don't understand anything

there is syringe to use by oil based injectable?

something is getting lost in translation. it should NOT be that hard to inject with a 22g needle but its NOT supposed to be instant , it does take 10-30 seconds for some injections.

 

[balboa270]

Man 22 will get r done inject slowly or is the plunger hard to push? That's normal on some to if that's the case push and pull while empty to loosen the rubber plunger before you pull from vile calm down

 

[net4sat]

man I can NOT push THE fucking syringe!! in my muscle or out
it very hard to puching

 

[balboa270]

Loosen the god dam plunger first by pull all the way and pushing several times

 

[net4sat]

yes the plunger very very very very very hard to push with oil (test)

 

[balboa270]

Loosen the god dam plunger first by pull all the way and pushing several times

This and warm

 

[DADAWG]

yes the plunger very very very very very hard to push with oil (test)

it must be a defective syringe or something has gotten stuck in the needle and stopped it up . try changing needles.

 

[frazier512]

what chem are you injecting? and into what muscle?

 

[MeatHead96]

WTH I inject with 29g slin pins and don't have issues. When its heated it takes time to push through but it works.

 

[balboa270]

Look if the rubber is cold it will be hard to push. Heat the syringe push and pull while empty to loosen plunger on all NEW injections this is normal with some syringes definately feed store pins.

 

[net4sat]

it must be a defective syringe or something has gotten stuck in the needle and stopped it up . try changing needles.

I change syringe and lost 2 test ampule

 

[net4sat]

what chem are you injecting? and into what muscle?

test p, in R-L delt

 

[net4sat]

WTH I inject with 29g slin pins and don't have issues. When its heated it takes time to push through but it works.

heated! what? and by what

 

[balboa270]

Dude why are you not listening to me with water