getting the excess out of the vial....

[brooklyn185]

any suggestions or tips appreciated. How do you guys get every drop out of the vial. I was thinking about heating it up and then turning it over and letting it run down. Also, very difficult pulling the last draw; lots of bubbles and took forever. There appears to be a little short of another full load but would like to use it up.

Also, the pin broke and stayed inside the HCG vial...any issues continuing to use.

 

[Teutonic]

rip the top off the bottle and back load the last 1 or 2 cc s into syringe. Pour into syringe place stopper onto back of syringe, invert push out air...g t g.


but wash your hands first

 

[Mprtz]

I just slowly withdraw the needle when drawing so that the tip is flush with the inside surface of the stopper.
Hold the vial level and then tilt slighly in all directions while drawing the remaining product along with a little air.

I never have more than a drop at most left in the vial when doing this.

 

[FlyMolo]

I just slowly withdraw the needle when drawing so that the tip is flush with the inside surface of the stopper.
Hold the vial level and then tilt slighly in all directions while drawing the remaining product along with a little air.

I never have more than a drop at most left in the vial when doing this.

But bro you lost all your gains because everyone knows they are in the last drop of a vial.

 

[Mprtz]

But bro you lost all your gains because everyone knows they are in the last drop of a vial.

Pop the stopper and do a number?

 

[Megatron28]

I just slowly withdraw the needle when drawing so that the tip is flush with the inside surface of the stopper.
Hold the vial level and then tilt slighly in all directions while drawing the remaining product along with a little air.

I never have more than a drop at most left in the vial when doing this.

This is what I do too.

 

[STAUNCHED427]

I just slowly withdraw the needle when drawing so that the tip is flush with the inside surface of the stopper.
Hold the vial level and then tilt slighly in all directions while drawing the remaining product along with a little air.

I never have more than a drop at most left in the vial when doing this.

Same, but what seems like the last drop is at the very most .5ml, for me anyway. When I calculate a blast where it's at say 3ml per week and I have a 10 ml vial, just for convenience sake I say 1 vial = 3 weeks etc