Heating the oil before injecting.

[Footballstar74]

This the first time i did it. I put a cup of water in the Microwave for a min. Then a put my Omna in the cup while it was still hot for about 90 secs. Did i hurt the oil? B/c this is the first time i am not feelin sore after an injection.

 

[tonee]

heating it up makes the oil thinner and easier to push into your muscle which ultimately relieves the muslce of some pain... You could also just run the syringe under hot water for a minute or so. U dont have to go through the trouble of using the microwave.

 

[Mudge]

You wont hurt the oil, as for hurting the gear how hot did you go? I seriously doubt it was that hot though enough to worry.

I used to go about coffee temp or so, but really dont do that any longer as I dont need to. I would imagine it may help spread the oil better inside the body though which could be of benefit.

 

[bruski]

heating it up makes the oil thinner and easier to push into your muscle which ultimately relieves the muslce of some pain... You could also just run the syringe under hot water for a minute or so. U dont have to go through the trouble of using the microwave.

Make sure if your run the syringe under hot water you dont get any water on the pin it has to stay sterile.
Also you can try a hair dryer it works for me.

 

[DADAWG]

i run the barrel of the syringe under hot faucet water until i count to 100

 

[stonecold54]

i run the barrel of the syringe under hot faucet water until i count to 100

you actually stand there and count to 100. LOL I can just picture that.


I do the same thing though I just estimate though, no exact count.