Heating up gear...inject hot or cooled down?

[PoppaPump456]

I am going to run syringe under hot water for 1-2 minutes then pin. My only question is should I wait a little bit before injecting or do it immediately after I take it from under the water?

Also, can anything like air bubble form since you are thinning it out in the syringe?

Thanks!

 

[Youngblood43]

You can inject it immediately after! As far air bubbles I never worry about them, you need a good ammount of air to do any harm.

 

[Chainman]

You want enough air in the barrel to push all the gear out of the syringe so you don't throw it away

 

[justin h]

Alittle warm...alittle air..and your good.

 

[PoppaPump456]

Any chance of over heating? I worried it is going to feel weird or I'll do it wrong some how

 

[toothin]

I prefer heating the vial with a heating pad, draw, pin.

 

[jw2031]

Why would you want to heat it?

 

[clsmth700]

You can inject it immediately after! As far air bubbles I never worry about them, you need a good ammount of air to do any harm.

x2

 

[clsmth700]

Any chance of over heating? I worried it is going to feel weird or I'll do it wrong some how

no lol

warm/hot water from the tap is not going to boil your gear and scald yur insides lol

 

[clsmth700]

Why would you want to heat it?

gear IM quicker & smoother

with less pi pain

 

[noway55]

You don't have to wait unless you put it under boiling water or something crazy

 

[H 3 L L S M A N]

I prefer heating the vial with a heating pad, draw, pin.

Great idea with the heating pad.

 

[Kuilontli]

I've been using a heating pad since shot #3, before that I went all Mexican and used uncooked rice inside a sock warmed in the microwave. I believe is easier to inject when is warm. But I dont like to warm up the vial, just the syringe loaded with gear.

It would take longer to warm the entire vial because of the volume/air in it.

 

[Kuilontli]

I've been using a heating pad since shot #3, before that I went all Mexican and used uncooked rice inside a sock warmed in the microwave. I believe is easier to inject when is warm. But I dont like to warm up the vial, just the syringe loaded with gear.

It would take longer to warm the entire vial because of the volume/air in it.