Help. The pain is unreal

[TitaniumDog]

But its kind of a good pain.
Same reason my girlfriend likes getting fucked in the ass...says the pain makes it feel soooo good.

 

[LDbuilt]

I was limping like a motherfucker the first few times I injected prop into my quads. Prop is know to make the muscle more sore than enth. I usually warm my test up with a hair dryer. I find it much quicker and less wet. Also try to massage the muscle for a bit after the injection. Helps the test spread throughout the muscle.

 

[cody5001]

im on my first cycle of test e. 250 mg 2 times /week. first time i did my right quad hurt like hell limped for a week. i rotate my quads and delts. second time i did my left quad sore for a few days. last week did my right quad and was sore for only a day or so. point being im fairly certian its virgin muslcle. ive also learned to slow wayyy down while injecting. its takes me about 45 seconds to a minute to inject. that really seems to help me. good luck bro. it gets better. oh and i use 23 guage pins and seems to work for me. in the future i plan on using 18 gauge to draw and 25 to inject. i think that would also eliminate pip

 

[100lbulua]

Virgin muscles lol. Jk prop hurts

 

[TroyDiesel25]

The 5 Steps To Overcoming Prop Pain, By Troy Diesel

1. Use a higher gauge pin

2. Cut the prop with grape seed oil using a 1:1 ratio

3. Heat the oil in the pin prior to blast with a hair dryer

4. Massage muscle post injection using handheld massaging device or bare hand

5. Stop being a b*tch

 

[Rugbug61]

20 guage plus prop its going to hurt bro

^^^THIS^^^

Try 25gx 1 1/2" take your time pinning, PIP can suck if jabbed too fast, rotate sites, consider delts too! Prop can be painful as well!

 

[Rugbug61]

the 5 steps to overcoming prop pain, by troy diesel

1. Use a higher gauge pin

2. Cut the prop with grape seed oil using a 1:1 ratio

3. Heat the oil in the pin prior to blast with a hair dryer

4. Massage muscle post injection using handheld massaging device or bare hand

5. Stop being a b*tch

yep

 

[gulfvet]

Hope you guys can chime in on this, i had the same problem with tren ace when i emailed my supplier and told him i could hardly walk he to me to put a strait pin in the vial to vent it and place in the oven at 165 degrees for 15 min, said this would kill any bacteria in the vial if it was contaminated, then before each inject heat it in hot water for 2-3 min and inject 60 sec for every cc, i was woried it would ruin the gear but he said they bake all batches this way as part of the sterilization process and it wouldnt hurt it i did all this and it did work i got minimal pain after this

 

[buddye]

20 guage ? Damnnnnnn...

Man the fuck up, guys. I poke with 18 gauge. Who wants to take all day to draw or inject? You gotta just say fuck it. Jab and plunge. Pinning ain't for pussies.

 

[gulfvet]

man up right buddye, that is solid advice, hey guys if your pinning bacteria it will be ok if you use an 18 gauge jamm it and hit the gym, forget the discoloration and the fever, the swelling all signs of serious infection it will be ok as long as you dont look like a pussy, my point was that it can be contaminated which can be very serious dosent hurt to rule it out for the saftey of keeping your limbs, supposed to be good advice here for people who need info, not suppose to down newbies and call them pussies, as for me im a war veteran and an if an 18 gauge needle makes you tough then what ive endured sould make me a god, hope this is a little helpful for those who need it dont get discouraged at people like this..................stay up

 

[busterdouglas]

hey man ive had some great prop experience in the past and horrible experience here lately...i even made a thread asking for advice. I'm baking some grapeseed oil as we speak and gonna dillute my shit to see if it helps with the pain. I'll let you knw how it goes