How can you tell?

scottrebel

New member
I just got in an order of Testabolon test C 200mg in a 10 ml vial. I took 2 mg and I'm not sure it's any good. I placed in the fridge and unlike my last bottle it didn't crystalize or cloud up. How can I be sure it's not bunk? Plus on top of that the injection sight seems swollen. No pain; just swollen.
 
Iv never used tren but the way iv always tested to see if my gear is real my dad has a doctor who perscribes him a shit tone of test cyp so I kno that's real and he tought me to tast a drip of it ..test has a specific tast u will never forget so I always tast new gear ...well not anymore cause I don't ? My conection anymore but like I said dnt kno if tren is same but test damn sure is
 
I think you mean 2mL? Forcing a bottle to crash isn't really a reliable means of determining if it's legit or not - take it for 4-5 weeks and getting a blood test is the best way unfortunately. (Unless you have access to a spectrometer, which is unlikely.) I hope you have more than one vial, as 10mL isn't going to be much of a cycle. Don't forget that Aromatase inhibitor (AI) and PCT! :p
 
I just got in an order of Testabolon test C 200mg in a 10 ml vial. I took 2 mg and I'm not sure it's any good. I placed in the fridge and unlike my last bottle it didn't crystalize or cloud up. How can I be sure it's not bunk? Plus on top of that the injection sight seems swollen. No pain; just swollen.

First off, are you cycling or on TRT?? Second, I believe you meant you take 2ml or 200mg?? Third, why in the hell would you put your test bottle in the fridge? Keep it at room temperature. That is steroids 101 brah!! Fourth, are you joking?? Lastly, click on the link......http://bit.ly/105bBz9
 
Last edited:
Wow! Keep it cool. I'm doing a cycle. I read in here that test separates from the oil at low temps and that if they do just place under running warm water.
 
Wow! Keep it cool. I'm doing a cycle. I read in here that test separates from the oil at low temps and that if they do just place under running warm water.

Correct. You don't want the hormone coming out of the solution and crystalizing and getting those cloudy swirls. Generally if I get get gear that crashes, I put a needle in the vial top to vent and heat it for a bit until the swirls disappear and it is usually good to go. Just keep it in a drawer in your house. I left a vial out in my car during the winter and overnight. Next morning it was crystalized. Lesson learned.
 
If this was good gear wouldn't it have crystallized?

Not necessarily. Depends how cold your fridge gets. Either way, you will be fine. If it did come out of solution, then just put the vial in some warm water and it will come back in to the solution. 99% of the time when test is frozen, then just leaving it at room temperature for a few days will solve the problem. If not, again, you can put the vial in some warm water and that usually fixes the problem. The melting point for Test E is over 300 degrees F I believe. Again, just keep your test at room temperature and you will be fine. I am not sure at what temperature it would crash at.
 
What about the swelling I mentioned?

Some guys get swollen on their injection sites. Could be virgin muscle, too much or too little BA, how you injected it, level of hormone in injection, etc. There are several factors. The main thing is to keep an eye on it and make sure it is not getting red and hot to the touch. If it gets worse, then hit up a doctor for some antibiotics.
 

No need to bump nine minutes after your last post, sheesh. :p It's a pretty well respected lab on these boards. Check out Dr. Phoenix' log on here - he's a rep for the lab and has obviously had some pretty damn good gains on it since he's competing (and winning). I haven't had a chance to try it yet, but do plan on it in the future.
 
Back
Top