methenolone enanthate (primo)

Jimbo

New member
What's a good formula for converting methenolone enanthate powder to an injectible? Any suggestions?
 
Methenelone conversion instructions

Methenelone Enanth. for 5 grams
Needed
5 grams powder
18.75ml sesame oil
1.25ml BA 5%
1.25ml BB 5%
Syringes
Vial
Sterile Vial
Whatman sterile filter

1. Weigh out 5 grams of powder.
2. Place powder in vial.
3. Add BA & BB to the vial.
4. Heat oil in the oven to help sterilize it, heat to at least 212 degrees F. I usually heat my oil at 275 to be sure, I put the oil in a muffin pan, just fill one of the indentions this is plenty for these experiments. Also heat more oil than you need, as you will not be able to get it all out of the pan.
5. Add oil to the vial, save 2 ml of oil in the syringe for later. Gently shake vial.
6. Heat mixture if necessary. I like heating my powder products, by placing the vial in a frying pan, and placing it on the eye of the stove.
7. Place a 18 or 20 gauge needle in the sterile vial attach Whatman sterile filter.
8. Place another needle in the sterile vial to relieve the pressure.
9. Draw out solution with a syringe, run though Whatman filter.
10. Take other syringe with 2ml oil, run through Whatman into solution.

Makes 25 ml @ 200 mg/ml
 
Back
Top