scottssherwood
New member
Can anyone advise if they have ever used or are you able to use olive oil for dilution of some IP test enanthate? i see grapeseed and peanut oils are favored. why is this the case? thanks!
Olive Oil for dilution?
- Thread starter scottssherwood
- Start date
Stone
Hazardous
grapeseed has a lower viscosity (thinner) than most other oils. I wouldn't see a problem using olive oil as long as it was sterile- baked and filtered. But on the same note, I wouln't do it with all other oils being so readily accesible. Just go to a health store and pick up some grapeseed oil.
scottssherwood
New member
thanks stone! so then the best process for sterilization would be? i have immovable rubber stoppers on my vials.....heat them up on a frypan with a pin to let out gas?
SoCo4Fun
New member
I would just run it through a .20 syringe filter or use a .22 stericup
http://www.researchlabsupply.com/Scripts/prodView.asp?idproduct=133
http://www.researchlabsupply.com/Scripts/prodView.asp?idproduct=133
BigRonWannabee
New member
.22 syringe filter by hand is a BITCH with anything thicker than water. I wouldnt filter thick ass olive oil by hand for damn near anything short of a threesome with 2 really hot girls, a large sum of cash or something else reallly nice.SoCo4Fun said:
Long story short: go with grapeseed.
