Pins for drawing/injecting oil?

[kaz-o]

Currently I use 22g and it literally takes me 5 to 7 minutes to draw out 5mls. What size does everyone here prefer for drawing/injecting? I've been told the wider the hole the more it'll hurt.

 

[StoneColdNTO]

18 or 20g to draw
23 or 25g to inject

 

[blackbeard]

5mLs? what kinda cycle you running?

 

[kaz-o]

1000mg test cyp (200mg/ml) per week for 10 weeks

 

[Vigilance]

I draw and inject with a 23g.

 

[StoneColdNTO]

1000mg test cyp (200mg/ml) per week for 10 weeks

Good lord man....split it up into atleast two injections a week.

You'll get much more stable blood hormone levels.

 

[Chips]

22 - 23

 

[tommy39]

20 to draw and after hot water heat up 25 to inject.

 

[X-avier]

Listen to everything that StoneCold said.

 

[pharon]

i need to learn more abt syringes , its different sizes, is 22g larger or 23 is! im not sure till now!!

so guys, wat are the best web sites i could use ?

 

[updiliman]

i need to learn more abt syringes , its different sizes, is 22g larger or 23 is! im not sure till now!!

so guys, wat are the best web sites i could use ?

the smaller the gauge number, the "wider" the needle is.

i personally have a good experience with researchlabsupply, or check out the board sponsors. they're all good to go!

 

[pharon]

i use 23g to inject but i dont use a pin at all to draw !
i just remove the pin and incline the amp a little bit and draw....it takes me
abt 3 seconds.

 

[ruzzi360]

i use a 20 to draw and a 25 to inject...

 

[guinnessman5150]

23 to inject and 20 to draw here

 

[BigR]

use 25 to draw & inject...works fine for me

 

[Lethalius]

20g to draw
23 or 25g to inject. (lately it's all been 23g to inject).