prop crystalizing & pain

[BigRonWannabee]

Well I just made 100ml of prop @ 100mg/ml. It held for a few days, or so i thought until I took a close look at the botttom of the 100ml vial. I have a few rather large crystals floating around. My question is this: If I were to just heat it before shooting, wouldnt I be in for some serious pain when those crystals start forming in my ass? I used 2% BA and 7% BB. Is it better to just reheat and shoot in my situation or should I try to add more solvent and see it it wont hold?

 

[pullinbig]

if its for you just heat every time. i heat every thing i do cause it makes it flow better with less knots and disomfort. the depot may not crystalize in you cheekies as you hot ass is already 98.6f and you closet aint.

if you wanna play around got up to 5% ba and 15% bb and see if it holds there. try 3 and 9 if you want. dont go over 5 and 15 though. if it dont hold there it aint gonna hold. and you getting a lot of solvent then too. thats 20%.

 

[BigRonWannabee]

I do have a pretty hot ass huh? LOL, good point about the temp difference bro, I guess Ill try it out and see what happens.

 

[Ifrit]

That sucks to hear, I was going to use 2%BA and 7%BB myself on the propionate.

 

[pullinbig]

5 and 15 dont hurt nothing.

 

[ld50]

5 and 15 dont hurt nothing.

'tsup bro?

always works for me. I need to get out of my rut though and start experimenting with lower solvent ratios.

 

[BigRonWannabee]

That sucks to hear, I was going to use 2%BA and 7%BB myself on the propionate.

Try it out, I know a few people who have stable prop at those ratios.

 

[pullinbig]

what up ID? 50?

 

[pullinbig]

and oh yeah. i prefer the long ester test cause yo can make um 500mg/ml. enan goes 500 with no solvents and almost pain free. =0)

 

[BigRonWannabee]

what up ID? 50?

I think its LD50, not I.

 

[ld50]

I think its LD50, not I.

that is correct. no offense taken from PB though.

 

[pullinbig]

okie dokie LD. lolololol

 

[chatbear]

I've always been able to get test prop to hold at 100mg/ml using only 5% BA and no BB.
It'll hold for a month or 2, I make small 20ml at a time for myself so it sits less time. but I've never had a prob with it holding at 100mg/ml for 2 months.
but with 5%BA and 15% BB I've had good with it holding 200mg/ml

 

[pullinbig]

was that pain free troop? was that syno or raw powder you used?