safe to inject?

[sprucegoose]

Made a batch of Test Enan. 250mg/ml last night. I used a new stove, however, and the new one is apparently much stronger. After heating my solution of enan powder, grapeseed oil, and benzyl alcohol; I transferred it from the beaker to the syringe and then filtered it into the vial. After I was finished I noticed that the syringe I used to filter the solution into the vial was a little melted where the whatman connects to the syringe and the rubber was a little disfigured on the plunger. Damn was I pissed off. Do you guys think any of the melted plastic or rubber got into my final solution? The color is perfectly normal and all. ANy help would be appreciated.

 

[tommy_big_guns]

I think I would refilter just to be safe. Its probably alright though.

 

[pullinbig]

its fine.

 

[Mudge]

You deformed it but I seriously doubt you truly melted it. I've damaged a few plungers and had oil shoot out the back, you just have to be carefull with the temperature of the oil you draw into your syringes. Hot oil does pass the filter easier but you have to be patient...

 

[insaned]

yes, probably too hot!
and it should be fine for shooting.