Shooting oil with slin needle ?

[benefit]

ive tried 23 too small 22g is the best u can hardly tell the difference, maybe just the speed of the injection is slower.

 

[eastarr69]

wouldnt there be a better chance of getting an abcess if you did shoot sub?

E

 

[GymLift]

wouldnt there be a better chance of getting an abcess if you did shoot sub?

Nope. In fact, the opposite is true.

 

[pharon]

I know but a question remains : what happens when the oil is deposited sub-cutaneously ? Is it a waste of gear, is it effective at all ?

its not a waste of gear, it just takes more time to be absorbed...

 

[pharon]

dude you coludnt draw the oil into the slin syringe using a slin pin,and you couldn't get as much gear in the syringe seeing as most are about 1ml.

he can draw as much oil as he wants in a 3 or 5 mls syringe then replace the pin wiz a slin pin...

but i still think its a bad idea to use a slin for oil based drugs though, coz once i took a water based shot i.v using a slin pin ant it took the doc like forever..! it was 5 mls so letterly i was bored

 

[bignate]

Draw with a 3ml/22g syringe 1 ml, then squirt it into a 1 ml 27 g slin pin and inject in your delt. If you have low body fat 1/2 inch 27-29g should be fine in your delt. using Upjohn testosterone cyp or any oil base.

 

[liquidpain]

thanks for all these valuables inputs. I'll give it a shot (not pun intended)

 

[Mr. dB]

dude you coludnt draw the oil into the slin syringe using a slin pin,and you couldn't get as much gear in the syringe seeing as most are about 1ml.

I'm gonna try an experiment right now. I've got enough 'slin pins to waste one, and I've got plenty of oil left over from my last batch of homebrew. So, lets see if I can even draw the oil with the pin. Back in a minute...





...No. It took me several minutes to draw 0.1cc of cotton seed oil into a 29g 1cc insulin syringe. I could pull a full 1cc vacuum and the plunger would just pop back as soon as I let go.

Furthermore, I tried to shoot the oil out of the syringe into the toilet, and it came out not as a stream but as a slow dribble of droplets. It would be impossible to perform a valid injection with that hardware.

 

[bignate]

Not sure how the home brew will work but most all commercial oil base should. You can't draw with it but if you fill a 3ml syringe with 1ml gear using a 20-23 gauge pin, pull the plunger out of the slin pin and fill it, then push the plunger back in and aspirate it you should be able to inject without much of a problem.